Pioneer SUPER TUNER III DEH-203 Owner's Manual - Page 10
Browse online or download pdf Owner's Manual for CD Player Pioneer SUPER TUNER III DEH-203. Pioneer SUPER TUNER III DEH-203 21 pages. High power cd player with fm/am tuner
Print Page
Changing the Source
Parts Identification
{8} Source
Changing the Source
Each time the button [8] is pressed, the
source will change in the following
sequence:
Built-in CD player - Tuner -- OFF
* If there is no disc in the built-in CD player,
the source will not change to "built-in CD
player".
10
Adjusting the Audio
Parts identification
{2} Volume/Audio adjustment
111} Shift
{13} Attenuator
(26) Loudness
Mode Selection
Each press of button [11] changes the mode
as follows:
Volume adjustment (V}-~ Balance
adjustment (F/B) - Tone adjustment
(BS/TR} ~~ Loudness adjustment (LOUd}
+ When you're adjusting fader, balance,
bass or treble, the indicator will stop at
the center setting. About 8 seconds after
adjustment, the display returns to its
previous state.
Volume Adjustment
Pressing the (+) side of button (2] increases
the volume, while the (-} side decreases it.
(Display shows "V-00" ~ "V-30"}
» When driving your vehicle, be sure to
keep the volume of the unit set low
enough to allow you to hear sounds
coming from outside.
Balance Adjustment
Press button [11] to select balance
adjustment mode. ("F" appears on the
display.) Adjust the fader using the (+) or (}
side of button [2]. To adjust the balance,
press either the (~€) or () side of button [2]
to turn on B.
Fader
Press the (+) side of button [21] to raise the
volume of the front speaker only. Press the
(~} side of the button to raise the volume of
the rear speaker only.
(Display shows "F-F9" ~ "F-RQ")
+ Please set "F-0" when using 2 speaker
system.
Balance
Pressing the {+} side of button [2] shifts the
balance to the ieft speaker, while the (*}
side shifts it to the right speaker,
(Display shows "B-L9" ~ "B-R9")
oe e o