Pioneer X-CM32BTD-k/-w Operating Instructions Manual - Page 5

Browse online or download pdf Operating Instructions Manual for CD Player Pioneer X-CM32BTD-k/-w. Pioneer X-CM32BTD-k/-w 44 pages. Cd reveiver system

Print Page

Before you start

Chapter 1:

Before you start

What's in the box

Please confirm that the following accessories are in the box

when you open it.

• Remote Control

• AAA batteries (R03) x 2

• Power cord

• Speaker wire x 2

• DAB/FM wire antenna

• Non-skid pads x 8

• iPhone/iPad stand

• Warranty card

• Operating instructions (this document)

Loading the batteries in the

remote control

Open the rear lid and load the batteries as

illustrated below.

Close the rear lid.

CAUTION

• Do not use any batteries other than the ones specified.

Also, do not use a new battery together with an old one.

• When inserting the batteries, make sure not to damage

the springs on the battery's  terminals. This can cause

batteries to leak or over heat.

• When loading the batteries into the remote control, set

them in the proper direction, as indicated by the polarity

marks ( and ).

• Do not heat batteries, disassemble them, or throw them

into flames or water.

• Batteries may have different voltages, even if they are the

same size and shape. Do not use different types of

batteries together.

• To prevent leakage of battery fluid, remove the batteries

if you do not plan to use the remote control for a long

period of time (1 month or more). If the fluid should leak,

wipe it carefully off the inside of the case, then insert

new batteries. If a battery should leak and the fluid

should get on your skin, flush it off with large quantities

of water.

• When disposing of used batteries, please comply with

governmental regulations or environmental public

institution's rules that apply in your country/area.

WARNING

• Do not use or store batteries in direct sunlight or other

excessively hot place, such as inside a car or near a

heater. This can cause batteries to leak, overheat,

explode or catch fire. It can also reduce the life or

performance of batteries.

Using the remote control

The remote has a range of about 7 m at an angle of about 30º

from the remote sensor.

30°

7 m

Keep in mind the following when using the remote control:

• Make sure that there are no obstacles between the

remote and the remote sensor on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the unit's

remote sensor.

• Remote controllers for different devices can interfere

with each other. Avoid using remotes for other

equipment located close to this unit.

• Replace the batteries when you notice a fall off in the

operating range of the remote.