Pioneer X-CM42BTD-k/-w Operating Instructions Manual - Page 37

Browse online or download pdf Operating Instructions Manual for CD Player Pioneer X-CM42BTD-k/-w. Pioneer X-CM42BTD-k/-w 44 pages. Cd reveiver system

Print Page

Additional information

Cautions on use

When moving this unit

When moving this unit, be sure to first check that there is no

disc loaded and disconnect the iPod/iPhone/iPad. Then press

 STANDBY/ON, wait for "STANDBY" disappears on main

display to turn off, then unplug the power cord. Damage may

occur if the unit is transported or moved with a disc inserted,

or when another device is connected to the iPod/iPhone/iPad

connector port, USB terminal, or AUDIO IN mini-plug jack.

Place of installation

• Choose a stable place near the TV or stereo system being

used with this unit.

• Do not place this unit on top of a TV or color monitor. Also

install it away from cassette decks and other devices

easily affected by magnetic forces.

Avoid the following locations:

• Places exposed to direct sunlight

• Humid or poorly ventilated places

• Extremely hot places

• Places exposed to vibrations

• Places in which there is much dust or cigarette smoke

• Places exposed to soot, steam or heat (kitchens, etc.)

Do not place objects on this unit

Do not place any objects on top of this unit.

Do not obstruct the ventilation holes.

Do not use this unit on shaggy rugs, beds, sofas, etc., or

wrapped in cloth, etc. Doing so will prevent the heat from

dispersing, leading to damage.

Do not expose to heat.

Do not place this unit on top of an amplifier or other

component that generates heat. When rack mounting it, to

avoid the heat given off by the amplifier or other audio

component, place it on a shelf below the amplifier.

• Turn off the unit's power when not using it.

• Depending on signal conditions, striped patterns may

appear on a TV screen and noise may enter the sound of

radio broadcasts when the unit's power is on. If this

happens, turn the unit's power off.

About condensation

If this unit is moved suddenly from a cold place into a warm

room (in winter, for example) or if the temperature in the room

in which this unit is installed rises suddenly due to heater

operation, etc., water droplets (condensation) may form

inside (on operating parts and the lens). When condensation

is present, this unit will not operate properly and playback is

not possible. Let this unit stand at room temperature for 1 or

2 hours with the power turned on (the time depends on the

extent of condensation). The water droplets will dissipate and

playback will become possible. Condensation can also occur

in the summer if this unit is directly exposed to the air flow

from an air-conditioner. If this happens, move this unit to a

different place.

Cleaning the product

• Unplug the power cord from the power outlet when

cleaning this unit.

• Clean this unit using a soft cloth. For tough dirt, apply

some neutral detergent diluted in 5 to 6 parts water to a

soft cloth, wring out thoroughly, wipe off the dirt, then

wipe again with a soft, dry cloth.

• Alcohol, thinner, benzene, insecticides, etc., could cause

the print or paint to peel off. Also, leaving rubber or vinyl

products in contact with this unit for long periods of time

could mar the cabinet.

• When using chemical-impregnated wipes, etc., read the

cautions included with the wipes carefully.

Cleaning the lens

This unit's lens should not become dirty in normal use, but if

for some reason it should malfunction due to dust or dirt,

consult your nearest Pioneer authorized service center.

Although lens cleaners for players are commercially

available, we advise against using them since some may

damage the lens.