Pioneer BDP-LX70A System Firmware Update Instructions - Page 3
Browse online or download pdf System Firmware Update Instructions for DVD Player Pioneer BDP-LX70A. Pioneer BDP-LX70A 5 pages. System firmware update instructions for bdp-lx70a
Also for Pioneer BDP-LX70A: Catalog (20 pages), Update Instructions (5 pages)
Print Page
E. Update the player's system firmware:
REMARKS:
Use the front panel buttons to carry out all actions. DO NOT use the remote control buttons.
The update process can take anywhere from 10 to 60 minutes.
The disc tray will open at the end of update process, so if you have your player in an
enclosed space (i.e. an entertainment center), be sure to allow enough space for the disc
tray to open without bumping anything.
DO NOT touch the disc tray or the disc until the update has finished.
If you have any problem during the update process, please refer to the firmware update FAQ
included in this document or you can call Pioneer Customer Support Center.
PROCEDURE:
1. Press the "STANDBY/ON" button to switch the unit on.
2. Press the "OPEN/CLOSE" button to open the disc tray.
3. Place the UPDATE disc you created on the disc tray.
4. Press the "OPEN/CLOSE" button on the front panel to close the tray.
"DISC-DWLD" will appear on the front panel display of the player.
WARNING!!
DO NOT unplug the power cable and DO NOT press the "STANDBY/ON" button until the
unit switches into standby mode as described in step 7. Doing so may result in your
player becoming unresponsive and will then need repairs.
5. After a few minutes the disc tray will open and the firmware update begins. (In some cases,
the disc tray may take longer than a few minutes to open)
DO NOT touch the disc or tray during the firmware update.
6. The messages (DOWNLOAD, etc.) will appear on the front panel display of the player.
DO NOT touch the disc or tray during the firmware update.
Note that from this point, the update process can take from 5 to 60 minutes.
7. The message "DL OK" will appear on the front panel display for a few seconds after the
firmware update has finished. The unit automatically switches into standby with the disc
tray remaining open and the lights on the front panel will be off.
8. Remove the UPDATE disc from the disc tray.
9. Press the "STANDBY/ON" button to switch the unit on.
10. Check the firmware version (see step A).
If the version has not been upgraded to 3.81 then confirm that the files on the disc are the
correct ones as described in step D and perform the update again in step E.
If the version is 3.81 then the firmware update was successful. The player is now ready for
use.
All manuals and user guides at all-guides.com