Pioneer CP-VSL3 Installation And Usage Instructions - Page 8

Browse online or download pdf Installation And Usage Instructions for Speaker System Pioneer CP-VSL3. Pioneer CP-VSL3 20 pages. Hung on wall unit

Print Page

Fasten the mounting fixture to the wall

When fastening the fixture to the wall, use a minimum of

six screw locations, including the four holes at the top and

bottom of the fixture (✱ marks). Mounting screws are not

furnished. Depending on the construction of the wall,

drywall anchors*

necessary; be sure to provide fully sufficient*

the speaker.

Anchors should have minimum strength of

0.3kN (Newtons).

NOTE

A safety factor of x4 or more should be

provided.

Install bushings

Install two bushings per speaker. The bushing is installed

so that the bushing's flange is separated slightly from the

fixture's surface; this helps prevent the speaker from

falling suddenly in the event the fixture should

accidentally become detached from the wall. Use drywall

anchors or other means to provide ample strength.

Bushing

or other reinforcements may be

Wall

Bushing

Screw

Mounting

fixture

Attach safety strap to wall

Attach the safety strap to the wall. Using anchor bolts or

other means as necessary, provide ample support strength.

The strap is an important safety device to prevent the

speaker from falling, and should be installed in all cases.

support for

Connect speaker cords and pass through

mounting fixture

Connect the speaker cords and pass them through the

square hole on the bottom of the mounting fixture.

If you wish to pass speaker cords through the rear of the

mounting fixture, use either of the two holes on the bottom

of the fixture, then pass the cord through any of the three

round holes (φ 30) on the rear surface of the fixture, as

shown.

• When threading speaker cords from rear of speaker

Insert upper plate into mounting fixture

While passing the speaker's terminals through the square

hole in the fixture's bottom, set the speaker onto the

fixture, then place the upper plate onto the top of the

speaker as you insert the upper plate's tab into the

opening on the top of the fixture.

Safety strap

Use either of these

When accessing

speaker cords the

rear of the speakers,

use one of the three

round holes (φ 30) in

the rear surface of

the mounting fixture.

Opening