Pioneer PDP-S27-LR Operating Instructions Manual - Page 3

Browse online or download pdf Operating Instructions Manual for Speaker System Pioneer PDP-S27-LR. Pioneer PDP-S27-LR 28 pages.
Also for Pioneer PDP-S27-LR: Service Manual (4 pages)

Print Page

2 Attach the speakers to the display.

Install the unit marked "RIGHT" on the right side of the display.

Hexagon socket

head screw

Install the unit marked "LEFT" on the left side of the display.

Plasma display

1 To attach the speakers to the display, start by placing the

upper screw where indicated, tightening until there is a

small space of about 5mm between the head of the screw

and the display.

2 Check the rear of the speakers for the LEFT and RIGHT

indicators to make sure you are attaching the correct

speaker to the corresponding right or left side. Make sure

the UP mark is pointing up, and then attach the speaker

by fitting the upper mounting over the head of the screw

and sliding down until snug.

3 Affix the lower fitting to the display and tighten the screw

about halfway.

4 Adjust the position so that the gap between the speaker

and the display is uniform, and then tighten the screws

firmly.

NOTE:

÷ When the display is to be moved after speaker

÷ The grille nets are designed to protect the speakers,

Plasma display

CONNECTION TO A PLASMA

DISPLAY

1 Connecting the speaker cables

Before connecting the speaker cords, unplug the plasma

display from the power outlet. After you have finished

connecting up, plug the unit back into the power outlet.

1 Connect the input terminals of the speaker system and

1. Push the lever, insert the cable into the hole, and release

2. For the output terminals on the plasma display, push the

Hexagon socket

head screw

÷ After connection to the terminals, pull lightly on the cable

÷ When cable cores stick out and ª and · lines are short-

÷ When the polarity is reversed for one speaker (left or right)

÷ If you insert the speaker cord too far so that the insulation

installation, do not hold the display by the speakers. Hold

the bottom of the display to move it.

however excessive force (such as pushing on, or insert-

ing objects between the grille nets) may result in dam-

age.

the speaker output terminals of the plasma display with

the accessory speaker cable. Make sure the positive (ª)

and negative (·) terminals match when connecting.

the lever.

· terminal (black) ª terminal (red)

White

To the· terminal

(Speaker input terminals of the speaker system)

lever, insert the cable into the hole, and release the lever.

ª ·

to confirm that the tips of the cable are properly con-

nected to the terminals. An imperfect connection can

cause sound interruptions and noise.

circuited, an excessive load will be applied to the plasma

display and the operation will stop or trouble will be

caused.

at the time of connection to the plasma display, the bass

reproduction will be reduced, the sound positioning will

be lost, and a correct stereo effect will not be obtained.

is touching the speaker terminal, you may not get any

sound.

< right >

English

Input terminal of speaker

White with gray line

To the ª terminal

Output terminal of plasma

display

< wrong >