Pioneer S-A4SPT-PM Operating Instructions Manual - Page 3

Browse online or download pdf Operating Instructions Manual for Speaker System Pioneer S-A4SPT-PM. Pioneer S-A4SPT-PM 48 pages. A/v receivers / cd player / integrated amplifier / fm/am tuner / dvd recorder / multi-format dvd player / speaker systems
Also for Pioneer S-A4SPT-PM: Catalog (8 pages), Catalog (10 pages)

Print Page

Pioneer S-A4SPT-PM Operating Instructions Manual

Note: Pioneer refuses any responsibility for damage

or accidents resulting from improper installation.

• Each speaker weighs 3.7 kg. Select a location for

installation with stable surface, providing sufficient

distance between the speaker system and nearby walls

as shown in the accompanying illustration.

The emphasis produced by the bass speakers (woofers)

can be adjusted to some degree by varying the distance

between the speaker system and the wall behind it.

Adjust the distance between speakers and side walls to

eliminate any subject difference between right and left

speakers.

50 cm

• The most natural stereo experience will be produced

when right and left speakers are equidistant from the

listening position. Speaker cables should also be the

same lengths for right and left speakers.

50° to 60°

• When placed beside a television set, right and left

speakers should be installed so far as possible in the

same plane as the television screen.

• In order to produce optimum breadth of sound when

used in conjunction with a television, install the

television in the center between the two speakers, and

set the speakers at distances from the television such

that the angle between the speakers and listener is

about 50° to 60°.

• In rooms with hard surfaced floors and walls, sound

may be reflected off the floor and walls, creating echoes

or harmonics. In such cases, it is recommended to

adjust the sound characteristics through the use of wall

hangings, curtains, or drapes, or by placing a carpet on

the floor. Placing curtains all the way to the corners of a

room may help prevent speakers from producing

muffled sound. Likewise, if the wall opposite the

speakers (behind the listening position) is a hard wall,

placing a thick curtain on the wall may produce good

results by helping prevent the generation of standing

waves.

Applying non skid pads

The use of non skid pads is recommended depending on the

installation location. Apply the pads to the four corners of the

side of the speaker which will be on the bottom. Note that

depending on the location, the pads may not provide fully

sufficient traction to prevent slipping, so care should be

taken not to install the speakers in conditions where they

may be prone to slide.

Installing and removing the grille net

20 cm

The front panel grille net may be removed if desired. The

following instructions are provided for removal and

replacement of the grille net:

hands, pull gently forward, away from the speaker.

The lower side of the grille net will detach from the speaker

body.

speaker.

The grille net will detach from the speaker body.

holes on the corners of the grille net with the pegs on

the four corners of the speaker and press in slowly.

Connecting to an amplifier

This speaker system features banana-plug connections.

the amplifier's speaker output terminals and the speaker

system's input terminals.

The red terminal is the positive

negative

terminal, and the wire without the white line to the

terminal.

1 Trim a small bit of insulation from the tip of the cable,

exposing the wire cores; twist the cores before inserting into

the terminal.

Holding the lower edge of the grill net with both

Pull the top side of the grille net away from the

To replace the grille net on the speaker, align the

Turn off the power at the amplifier.

Connect each supplied speaker cable to one set of

, and the black terminal is

. Connect the wire with the white line to the

Non skid pads