Pioneer S-L8-LRW XE Operating Instruction - Page 41
Browse online or download pdf Operating Instruction for Speaker System Pioneer S-L8-LRW XE. Pioneer S-L8-LRW XE 48 pages. Stereo cd receiver; speaker system; stereo cassette deck
Also for Pioneer S-L8-LRW XE: Service Manual (3 pages)
Print Page
The tape deck is set up ready
to record
The tuner is set up ready to be
recorded
The on time is whatever was
last set for timer recording
Adjust it to what you want.
Remember: the time is
displayed as a 24-hour clock
The 'off ' time is automatically
set to an hour later than the
'on' time
Adjust it to what you want
Confirm that you're recording
to tape
1
Set up the tape deck/MD recorder.
If you're recording to tape:
Load a cassette tape, set the recording direction and reverse mode, and
switch on/off Dolby NR as required.
If you're recording to disc:
Load an MD into the recorder.
2
Set up the tuner/auxiliary component.
If you're recording from the tuner:
Switch to the tuner, and tune into the station (see page 19 for more
detailed instructions on this).
If you're recording from the auxiliary component:
Switch to that component and set it up for playback.
3
Select TIMER REC from the timer menu.
Remember: switch between timer menu options using the $ and ›
buttons; select the option by pressing
4
Set the recording start time:
First, set the hour:
Use the $ and › buttons to change the flashing hour display, then
press
.
SET
Next, set the minute:
Use the $ and › buttons to change the flashing minute display,
then press
.
SET
5
Set the recording end time:
First, set the hour:
Use the $ and › buttons to change the flashing hour display, then
press
.
SET
Next, set the minute:
Use the $ and › buttons to change the flashing minute display,
then press
.
SET
6
Select either tape or MD recording:
Use the $ or › button to switch between options, then press
-
TAPE REC
MD REC
After pressing
, the display shows you the settings you've just made,
SET
including the switch on and off times, and the components you're recording
to and from. The clock and record symbols in the display indicate that the
record timer is set.
Be sure to switch the system into standby mode before timer recording starts. (In standby
mode you can check the timer settings by pressing
After the recording has finished, the timer recording mode is automatically cancelled.
8 Using the Timer
.
SET
(only available if an MD recorder is connected)
.)
TIMER
.
SET
41