Ariston WMTF 623 H HK Instruction & Installation Manual - Page 6
Browse online or download pdf Instruction & Installation Manual for Washer Ariston WMTF 623 H HK. Ariston WMTF 623 H HK 16 pages. Top loading washer
Print Page
洗衣前準備
Preparation of the wash cycle
衣物分類 Sort the laundry
1. 將衣物置入洗衣桶內，開機前確保機門已關閉。
Load the washing machine, close the drum door and
check that it is closed properly.
2. 注入洗滌劑，如有須要可加其他衣物添加劑。
Pour in the detergent and any additives, as described
overleaf and in the instruction manual.
3. 關閉機門。
Closed the lid.
4. 旋動選擇旋鈕選取所需功能。選取程序的操作時間顯示於屏
幕上。開始/暫停指示燈會閃動。所選取轉速的指示燈會亮
起。本機將會於程序完結，或已設定預校洗衣程序後約 15
分鐘自動熄機。如須再次開啟本機，將程序選擇掣旋至 OFF
字樣，後再重新選取所須程序。
Turn the programme selector to the desired programme
and temperature. The time display shows the duration of
the selected programme (in hours and minutes), and the
indicator for the Start/Pause button flashes. The indicator
for the preset spin speed lights up. After the end of a
programme, or when a programme is selected but not yet
started, the washing machine will therefore switch off
automatically after about a quarter of an hour. To switch
the washing machine on again, turn the programme
selector to "Off" and afterwards to the desired programme
again.
選取所須功能 Select any desired option
當所取功能組合與洗衣程序不能兼容時，相關指示燈會自動熄
滅，所選取的功能組合會自動取消。
When the combination of programme and additional option(s)
is not possible, the indication lights switch off automatically.
Unsuitable
combinations
automatically.
預洗按鈕 Prewash button
適用於污漬較多衣物。此功能操作時間會延長約 15 分鐘。
Only for heavily soiled loads (for example sand, granular
dirt) sensible. Increases the cycle time by approximately
15 min.
選用預洗功能時，切勿使用洗衣液。
Do not use liquid detergent for the main wash when
activating the Prewash option.
省時程序按鈕 "Time Saver" button
系統設計配合以縮短洗衣時間。
Enable quicker washing by shortening the programme
duration.
建議使用此功能洗濯少量及污漬較少衣物。
Recommendable for small loads or only lightly soiled
laundry.
冷水洗衣按鈕 "Cold Wash" button
此功能設計配合於冷水洗濯衣物時，仍可有效潔淨衣物及達
至節能效果。
Saves energy used for water heating while maintaining
good wash result.
建議使用此功能洗濯污漬較少衣物。
Recommendable for lightly soiled laundry without stain.
使用此功能時，確保洗滌劑能用於冷水洗衣，溫度為 15 至
20℃。
Make sure that your detergent is suitable for cold wash
temperatures (15 or 20℃).
此功能可配合適用於冷水溫度的洗衣功能。
Mainly selectable on the lowest temperature step of the
programmes.
of
options
are
deselected
額外過水按鈕 "Extra Rinse" button
按此功能將會額外注入清水洗衣，而洗衣程序時間亦會延
長。
More water is added and rinse cycle is prolonged.
此功能適用於嬰兒及敏感人士清洗衣物。
This option is particularly suitable for areas with very soft
water, washing baby linen and helping people with
allergies.
脫水按鈕 "Spin" button
每一程序已預設有指定脫水旋乾速度。
Every programme has a predefined spin speed.
按下此功能以選取不同轉速。
Press the button to set another spin speed.
如已選擇 0 轉速，則程序至最後操作時會取消旋乾轉速，祇
作免旅排水。洗衣操作期間旋乾轉速則仍持續。
If spin speed "0" is selected, the final spinning is cancelled
but intermediate spin peaks remain during the rinse. The
water is drained out only.
預校開機時間 Delay Timer
預校開機時間掣為因應設定洗衣時間，如可設指定時間於夜間
洗衣。
The "Delay Timer" button allows the user to run the machine
at his convenience, for example at night when electricity is
cheaper.
選用預校開機時間功能的相關程序時，切勿使用洗衣液洗
衣。
Do not use liquid detergent when activating this function.
揀選所須乾衣轉速及功能。
Select programme, spin speed and options.
按預校開機時間按鈕，逐次按下以揀選所須時間(小時)。
Press the "Delay Timer" button several times to delay the
start by up to 23 hours.
完成選項後，預校開機時間按鈕指示燈亮後並熄滅。
Start the programme. The indication lamp over the "Delay
timer" button lights up and goes off when the programme
starts.
按下開始/暫停按鈕，預校開機時間會以倒數形式顯示。當
到達開機時間後，洗衣時間會顯示並取代開機倒數時間。
Once having pressed the "Start/Pause" button, the
countdown of the time delay begins. The time delay
indication on the display disappears when the programme
starts and is replaced by the remaining time.
按下開始/暫停按鈕啟動預校開機時間後，如須再調整開機
時間，可再次按下預校開機時間按鈕遞減開機時間。
After the "Start/Pause" button has been pressed, the
number of hours preselected can be reduced by pressing
again the "Delay timer" button.
取消預校開機時間功能 To cancel the Delay timer
按下開始/暫停按鈕前 before you press the Start/Pause
button:
將洗衣程序選擇掣旋至其他程序位置，或按下重置按鈕。
Turn the programme selector to another position or press
the Reset button.
按 下 開 始 / 暫 停 按 鈕 後 after you press the Start/Pause
button:
按下重置按鈕最少 3 秒，預校開機時間指示燈會熄滅。
Press the Reset button for at least 3 second. The start
delay indicator light goes off.
5