Pioneer S-VSL6C Operating Manual - Page 3
Browse online or download pdf Operating Manual for Speaker System Pioneer S-VSL6C. Pioneer S-VSL6C 13 pages. Pioneer s-vsl6c: operating instruction
Also for Pioneer S-VSL6C: Operating Instructions (4 pages)
Print Page
Assembly
Assembling the speaker stands requires use of a medium
Phillips screwdriver.
Connect speaker wires before assembly
Installation example 1 (Horizontal installation)
1. Affix mounting pads
Pads
2. Use two supplied screws to fasten the speaker stand to the
speaker
Installation example 2 (Vertical installation)
1. Affix mounting pad
Pad
2. Use 4 supplied screws to attach the accessory mounting
fixture to the speaker stand (Fig. a)
3. Use 2 supplied screws to attach the mounting fixture and
speaker stand to the speaker (Fig. b)
(Fig. a)
(Fig. b)
Pay special attention to choosing a safe installation
location when mounting the speaker vertically,
since it may tend to tip over.
Wall Mounting
• This speaker system is supplied with a mounting fixture for
wall mounting. When using the speaker system in a wall
installation, take full precautions to prevent the speaker
from falling.
• Check the wall location thoroughly to ascertain its ability to
support the weight of the speaker system.
• If you are unable to determine the structural strength of the
wall, consult a building professional before attempting to
install the speaker system on a wall.
• No screws or bolts are provided for use in a wall
installation. Supply your own threaded fasteners in
accordance with the wall or pillar's material structure and
strength.
• Install only on a vertically plumb surface. Installation at an
angle may result in dangerous loosening of the fixture,
causing a fall.
1. First decide on whether you will install the speakers
vertically or horizontally. Use commercially available
threaded fasteners (screws or bolts) to attach the accessory
mounting fixtures to the wall.
When installing the speakers horizontally, use two screws
installed at the two locations shown (left and right); when
using a vertical installation, place one screw in the center
as shown.
Wall hanging screws
(buy commercially)
Horizontal installation
2. Loosen the screws slightly to allow the mounting fixture to
be removed.
3. Attach the speaker wire to the speaker.
4. Use one provided accessory screw and one washer to
attach the accessory safety wire to the speaker as shown.
5. Use two provided accessory screws to attach the speaker to
the mounting fixture.
6. Use a commercially available screw or bolt and one of the
provided accessory washers to connect the loose end of the
safety wire to the wall.
7. Align the speaker with the screws installed in step 1, and
fasten to the wall.
Installation Example 1 (Horizontal installation)
Accessory screws
Vertical installation
Safety wire
Commercially
purchased screw
Washers
3
En