Pioneer PDP-502MXE Operating Instructions Manual - Page 16

Browse online or download pdf Operating Instructions Manual for Monitor Pioneer PDP-502MXE. Pioneer PDP-502MXE 33 pages. Pioneer corporation operating instructions plasma display pdp-502mxe

Print Page

Installation and Connections

Power cord connection

Connect a power cord after all component connections

have been completed.

PDP-502MXE power cord ratings

Cord .......................... Cross-sectional area 3 x 1.0 mm

Connector ................................................... 10 A, 250 V

(According to EN60320 Sheet C13)

Plug ................................ International use (10 A, 250 V)

Example:

: UK 13 Amp Plug with rated 13 Amp fuse

(According to BS1363)

EURO : 10 A/16 A 250 V (According to CEE 7, 1 V)

CAUTION

÷ Do not use a power supply voltage other than that indicated

(AC 100 - 240 V, 50/60 Hz) as this may cause fire or electric

shock.

÷ For the plasma display, a three-core power cord with a ground

terminal is used for efficiency protection. Always be sure to

connect the power cord to a three-pronged grounded outlet

and make sure that the cord is properly grounded. If you use a

power source converter plug, use an outlet with a ground

terminal and screw down the ground line.

How to route cables

Speed clamps and bead bands are included with this unit

for bunching cables together. Once components are

connected, follow the following steps to route cables.

<ARE1350> En

(According to CEE 13)

Organize cables together using the provided

speed clamps.

Insert 1 into an appropriate hole on the rear of the

unit, then snap 2 into the back of 1 to fix the clamp.

Speed clamps are designed to be difficult to undo

once in place. Please attach carefully.

To attach the speed clamps to the main unit

Connect the speed clamps using the 4 holes marked with

• below, depending on the situation.

To remove speed clamps

Using pliers, twist the clamp 90° and pull it outward.

In some cases the clamp may have deteriorated over

time and may be damaged when removed.

Bunch separated cables together and secure

them with the provided bead bands.

Note

Cables can be routed to the right or left.

* As viewed from the rear of the display.