Pioneer PDP-502MXE Operating Instructions Manual - Page 26

Browse online or download pdf Operating Instructions Manual for Monitor Pioneer PDP-502MXE. Pioneer PDP-502MXE 33 pages. Pioneer corporation operating instructions plasma display pdp-502mxe

Print Page

Additional Information

Cleaning

Regular cleaning will extend the life and performance of

this unit. The recommended way to clean the display and

related parts is described below.

Before cleaning, be sure to unplug the power cord from

the power outlet.

Cleaning the display panel body and remote

control

Do not under any circumstances use solvents such as

benzine or thinner for cleaner. Use of such liquids may

cause deterioration or peeling of paint from the display or

remote control unit.

Wipe the display and remote control gently with a soft

cloth. In the case of excessive dirt buildup, dampen a soft

cloth with a diluted neutral cleaning detergent and after

wringing the cloth thoroughly, wipe the component and

then dry it with a dry soft cloth.

Cleaning the screen

After dusting, wipe the screen gently using the supplied

cleaning cloth or a soft cloth. Do not use tissue or a rough

cloth. As the surface of the screen is easily scratched, do

not rub it or hit it with a hard object.

Cleaning the vents

As a general rule, use a vacuum cleaner about once a

month to clean the vents on the rear panel of the display

of dust buildup (set the vacuum cleaner to its weakest

setting when doing this).

Using the unit without cleaning it of dust will cause the

internal temperature to increase, resulting in possible

breakdown or fire.

Vents

<ARE1350> En

Vents

Inserting the batteries in the remote

control unit

While pressing down

lightly, slide in the

direction of the arrow.

Two AA (R6)

batteries

When handling the remote control unit

¶ Do not drop or shake the remote control.

¶ Do not use the remote control unit in a location subject to

direct sunlight, heat radiation from a heater, or in a place

subject to excessive humidity.

¶ When the remote control unit's batteries begin to wear out,

the operable distance will gradually become shorter. When this

occurs, replace all batteries with new ones as soon as

possible.

CAUTION

¶ Insert batteries so that the plus (+) and minus (–) sides are

aligned according to the markings in the battery case.

¶ Do not mix new batteries with used ones.

¶ The voltage of batteries may differ even if they are the same

shape. Please do not mix different kinds of batteries together.

¶ When not using the remote control unit for a long period of

time (1 month or more), remove the batteries from the remote

control unit to prevent leaking of battery fluid. If battery liquid

has leaked, thoroughly wipe the inside of the case until all

liquid is removed, and then insert new batteries.

¶ Do not charge, short, disassemble or throw the provided

batteries in a fire.