Ariston LFP 5P31 WLT X Instructions For Use Manual - Page 15

Browse online or download pdf Instructions For Use Manual for Dishwasher Ariston LFP 5P31 WLT X. Ariston LFP 5P31 WLT X 45 pages.

Print Page
PROBLEMS
POSSIBLE CAUSES
Racks are not fit to the end.
The door doesn't
lock.
The door is not lock.
The dishes are rattling against each.
The dishwasher
makes excessive
An excessive amount of foam has been
noise.
produced.
The selected program hasn't any drying
phase.
The dishes have not
The rinse aid has run out or the resolution
been dried.
is not adequate.
The dishes are made of non-stick or
plastic.
The crockery has not been arranged
properly.
The spray arms cannot rotate freely, being
hindered by the dishes.
The wash cycle is too gentle and/or deter-
gent efficiency is low.
The dishes are not
An excessive amount of foam has been
clean.
produced (see AFTER-SALES SERVICE).
The cap on the rinse aid compartment has
not been shut correctly.
The filter is soiled or clogged.
There is no salt.
The salt level is too low.
The adjustment of the water hardness is
not adequate.
The dishes and glas-
ses show calcination
The cap of the salt reservoir is not proper-
or a whitish film.
ly closed.
The rinse aid is used up or the dosage is
insufficient.
The dishes and
glasses are blue
The rinse aid dosage is excessive.
streaked or have a
bluish tinge.
Policy and standard documentation and additional product information can be found by:
Visiting our website www.aristonchannel.com
•
•
Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet).
•
When contacting our After-sales Service, please state the codes provided on your product's
identification plate.
The model information can be retrieved using the QR-Code reported in the energy label.
The label also includes the model identifier that can be used to consult the portal of the registry
at https://eprel.ec.europa.eu (available only on certain models).
SOLUTIONS
Verify that racks are fit to the end.
Vigorously push the door until you hear the "clack" sound.
Arrange the crockery correctly (see Loading the Racks).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see Filling the Detergent Dispenser). Restart the current
cycle by switching OFF the dishwasher, then switch it on again, select a
new program and press START/Pause. Please do not add any detergent.
Verify on the programs table if the selected program has the drying phase.
Add the rinse aid or adjust the dosage levels higher (see Filling the Rinse
Aid Dispenser).
It is normal the presence of drops of water (see Tips).
Arrange the crockery correctly (see Loading the Racks).
Arrange the crockery correctly (see Loading the Racks).
Select an appropriate wash cycle (see Programs Table).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see Filling the Detergent Dispenser). Restart the current
cycle by switching OFF the dishwasher, then switch it on again, select a
new program and press START/Pause. Please do not add any detergent.
Make sure the cap of the rinse aid dispenser is closed.
Clean the filter assembly (see Care and Maintenance).
Fill the salt reservoir (see Filling the Salt Reservoir).
Fill the salt reservoir (see Filling the Salt Reservoir).
Increase the values (see Water Hardness Table).
Check to have properly closed the salt reservoir cap.
Add the rinse aid or adjust the dosage levels higher.
Adjust the dosage rates below.
EN
IEC 436
:
15