Dinex TQ2T2D24 Operating & Maintenance Manual - Page 3

Browse online or download pdf Operating & Maintenance Manual for Outdoor Cart Dinex TQ2T2D24. Dinex TQ2T2D24 6 pages. Tq quiet series cart

Print Page

MAINTENANCE

IMPORTANT: Annually (or as needed) add glacier grease to caster

swivel mechanism to ensure the wheels remain Quiet while in use.

REMOVE RACK

Place one hand on rack and lift up on locking bracket lever and pull rack

clear from bracket (See figure 2). Repeat this action on other side and

rack should fall away from inside wall of cart. Lift rack off of pins and

remove from inside of cabinet (See figure 1). Repeat process for each

rack.

INSTALL RACK

Slide rack into cabinet at a 20 degree angle away from side wall so you

can clearly see the bottom holes of rack (See figure 1). Line up holes

on cone pins and let rack slide down on pins till they stop. Push rack

towards cabinet wall until rack locks into place on both locking brackets

(See figure 2). Rack should not be able to be pulled free easily when

rack is locked into place.

CHANGE RACK LOCATION (FOR DIFFERENT SIZE TRAYS)

Remove plastic plug in the pin location you wish to move the rack to

(See figure 3). Using a flat head screw driver unscrew cone pin and

screw into new pin location. Replace plastic plug in now vacant unused

hole. Repeat this process on both sides of rack cone pin locations

making sure you use the same hole location on both sides so the rack

stays parallel to inside cabinet wall. You will then loosen both hex bolts

(do not remove) until top locking bracket can slide free of slots (See

figure 4). You will push up on bracket and slide it to the next set of slots

(or last set) depending on which hole location you have moved your

cone pins to. Then let the bracket slide back down into the slot making

sure that the bracket is resting on the bolt shaft. Tighten screws with

hand tools so as to not strip threads on hex insert. "Power screw drivers

are not recommended for this operation".

Figure 1

GENERAL CLEANING

Open doors and lock them in the open position, remove the drain plug

and remove racks to clean, sanitize and dry the inside of cart thoroughly

(See figure 5). After cleaning, replace the racks and drain plug. Close

doors to clean outside of cart and using 2 or more people gently tilt

back cart and lay down on its back using support bars to clean the

undercarriage.

Figure 2

TQ Quiet Cart | 3

Figure 3

Figure 4

Figure 5