Aeotec Door / Window Sensor 7 User Manual - Page 7
Browse online or download pdf User Manual for Accessories Aeotec Door / Window Sensor 7. Aeotec Door / Window Sensor 7 10 pages.
Also for Aeotec Door / Window Sensor 7: User Manual (9 pages), Quick Start Manual (11 pages), User Manual (9 pages)
Print Page
31/07/2019
Firmware-Update over the Air.
This device is capable of receiving a new firmware 'over the air'. The update function needs to be supported by the
central controller. Once the controller starts the update process, perform the following action to confirm the firmware
update:
1. Wake Up the device by removing the cover.
2. The hit the tamper switch once.
Send a wake up notification.
In order to send your sensors new configuration commands from your Z-Wave controller or gateway, it will need to be
woken up.
1. Wake Up the device by removing the cover.
2. The hit the tamper switch once.
Note: Door / Window Sensor 7 remains awake until the housing is closed again.
Remove your Door / Window Sensor 7 from Z-Wave network.
Your sensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main
controller/gateway. To do this, please refer to the part of your gateways respective manual that tells you how to remove
devices from your network.
1. Set your Z-Wave controller into unpair mode.
2. Triple-click the tamper switch on Door / Window Sensor 7 within 1.5 seconds - this will cause the LED to blink
five times.
3. After a successful exclusion, it will light up its LED for 2 seconds then deactivate.
Reset your Door / Windows Sensor 7.
This device also allows being reset without any involvement of a Z-Wave controller. This procedure should only be used
when the primary controller is inoperable.
To manually factory reset:
1. Remove the cover of Door / Window Sensor 7
2. Press and hold tamper switch for 5 seconds until the red LED blinks.
3. Release the tamper switch
4. Immediately press and hold the tamper switch for 5 seconds until the red LED blinks.
Parameter Configurations.
https://aeotec.freshdesk.com/support/solutions/articles/6000218764-door-windows-sensor-7-user-guide
Door / Window 7 user guide : Aeotec Group
7/10