Aeotec MULTISENSOR 6 Manual

Browse online or download pdf Manual for Accessories Aeotec MULTISENSOR 6. Aeotec MULTISENSOR 6 10 pages. Z-wave water and flood sensor
Also for Aeotec MULTISENSOR 6: User Manual (13 pages), Manual (3 pages), User Manual (8 pages), User Manual (13 pages)

Print Page
Aeotec MULTISENSOR 6 Manual
Aeotec
Water Sensor 6
SKU: AEOEZW122
Quickstart
This is a secure Alarm Sensor for Europe. To run this device please insert fresh 1 * CR123A batteries. Please make sure the internal battery is fully
charged. Remove the battery tab by pulling it away from water sensor.
Turn the primary controller of Z-Wave network into inclusion mode, short press the products Action Button that you can find on the product.
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
(For more information about frequency regulations please refer to
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and
every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is
not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified
Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level
of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.

Product Description

Aeotec by Aeon Labs Water Sensor 6 brings intelligence to a new level, one that is suited to both safety and convenience. It contains 4 sensing points, which
would be more accurately to detect the presence and absence of water or detect whether there is water leak in some places of your home. The Water Sensor 6
has an inbuilt buzzer that can play alarm sounds to let you know when the water is detected. The Water Sensor 6 is also a security Z-Wave device that supports
Over The Air (OTA) for firmware updates.
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do
this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended
to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
the frequency coverage overview at Sigma Designs Website
).