Aeotec Dual Nano Switch ZW140 User Manual - Page 12

Browse online or download pdf User Manual for Switch Aeotec Dual Nano Switch ZW140. Aeotec Dual Nano Switch ZW140 15 pages.

Print Page

8-7-2019

Force the Nano to enter S1 external switch detection mode:

1. Tap the Nano button 4x times within 1-2 seconds which will force Nano to enter External Switch detection mode. (LED will flash blue)

2. Flip your external switch once, then wait at a minimum 10 seconds before you flip the switch again.

3. Now test your external switch.

Force the Nano to enter S2 external switch detection mode:

1. Tap the Nano button 6x times within 1-2 seconds which will force Nano to enter External Switch detection mode. (LED will flash green)

2. Flip your external switch once, then wait at a minimum 10 seconds before you flip the switch again.

3. Now test your external switch.

Set external switch using Configuration Command Class.

You can also set the external switch mode through Configuration Command Class.

Parameter 120 [1 byte] (for S1 control of OUT1) and Parameter 121 [1 byte] (for S2 control of OUT2) is the parameter that will set one of the 3 different modes. You can set

this configuration to:

(0) Unknown Mode

(1) 2-state switch mode

(2) 3-way switch mode

(3) Momentary push button Mode

(4) Enter auto switch detection mode

https://aeotec.freshdesk.com/support/solutions/articles/6000178928-dual-nano-switch-user-guide-zw132-and-zw140-

Dual Nano Switch user guide : Aeotec Group

12/15