Aeotec Smart Switch 7 Manual - Page 9

Browse online or download pdf Manual for Switch Aeotec Smart Switch 7. Aeotec Smart Switch 7 18 pages.
Also for Aeotec Smart Switch 7: User Manual (8 pages), Manual (6 pages)

Print Page

2. Make sure the product is powered. If not, plug it into a wall socket and power on; its LED will be breathing blue light

all the time.

3. Click Action Button once, it will quickly flash blue light for 30 seconds until it is added into the network. It will

become constantly bright yellow light after being assigned a NodeID.

4. If your Z-Wave Controller supports S2 encryption, enter the first 5 digits of DSK into your Controller's interface if

/when requested. The DSK is printed on its housing.

5. If Adding fails, it will bright red light for 2s and then become breathing blue light; repeat steps 1 to 4. Contact us for

further support if needed.

6. If Adding succeeds, it will bright blue light for 2s and then turn to Load Indicator Mode. Now, this product is a part of

your Z-Wave home control system. You can configure it and its automations via your Z-Wave system; please refer to

your software's user guide for precise instructions.

Note:

If Action Button is clicked again during the Classic Inclusion Learn Mode, the Classic Inclusion Learn Mode will exit. At

the same time, Indicator Light will bright red light for 2s, and then become breathing blue light.

3.4

How to remove the product from Z-Wave network

1. Set your Z-Wave Controller into its 'Remove Device' mode in order to remove the product from your Z-Wave system.

Refer to the Controller's manual if you are unsure of how to perform this step.

2. Make sure the product is powered. If not, plug it into a wall socket and power on.

3. Click Action Button 2 times quickly; it will bright violet light, up to 2s.

4. If Removing fails, it will bright red light for 2s and then turn back to Load Indicator Mode; repeat steps 1 to 3. Contact

us for further support if needed.

5. If Removing succeeds, it will become breathing blue light. Now, it is removed from Z-Wave network successfully.

3.5

How to factory reset

If the primary controller is missing or inoperable, you may need to reset the device to factory settings.

Make sure the product is powered. If not, plug it into a wall socket and power on. To complete the reset process

manually, press and hold the Action Button for at least 15s and then release. The LED indicator will become breathing

blue light, which indicates the reset operation is successful. Otherwise, please try again. Contact us for further support

if needed.

Note:

1. This procedure should only be used when the primary controller is missing or inoperable.

2. Factory Reset will:

(a) Remove the product from Z-Wave network;

(b) Delete the Association setting;

AEOTEC Engineering Specification

Page 4