Ariston GENUS PREMIUM EVO HP 65 Design, Installation And Servicing Instructions - Page 12

Browse online or download pdf Design, Installation And Servicing Instructions for Boiler Ariston GENUS PREMIUM EVO HP 65. Ariston GENUS PREMIUM EVO HP 65 44 pages. Wall-hung condensing gas boiler hp
Also for Ariston GENUS PREMIUM EVO HP 65: User Manual (17 pages), User Manual (24 pages), User Manual (32 pages)

Print Page

installation

The installation and fi rst ignition of the boiler must be

performed by qualifi ed personnel in compliance with current

national regulations regarding installation, and in conformity

with any requirements established by local authorities and

public health organisations.

Genus Premium EVO HP is designed to work individually or in

cascade (max 8 devices).

Is necessary that all requirements are met by the rules and

regulations for equipment equivalent to the total installed power

generators.

In particular, the local installation, security devices and fl ue exhausts

evacuation system should be adjusted to the total potential of the

cascade.

The requirements for installation in this manual concerning the

installation of a single device.

To install the cascade read the installation manual included in Kit.

Before installing the appliance

The boiler heats water to a temperature below boiling.

It should be connected to a heating system and to a domestic

water mains supply, both of which must correspond in size to the

performance and its power of the appliance.

Before connecting the boiler, it is fi rst necessary to perform the

following operations:

- Carefully wash the system piping in order to remove any screw

thread or welding residues, or any dirt which might prevent the

boiler from operating correctly.

- Make sure that the boiler is set up for operation with the type of

gas available (read the information on the packaging label and

on the boiler data plate).

- Make sure that there are no obstacles inside fl ue exhaust and that

it does not contain any discharge from other appliances, unless

the fl ue is meant to serve more than one user (in accordance with

current legal requirements).

- Where there is already a connection to existing fl ue exhausts,

check that these exhausts have been perfectly cleaned and are

without residues, because any disconnection could obstruct the

passage of fumes and create potentially dangerous situations.

- Make sure that, where unsuitable fl ue exhausts are attached, they

have been ducted.

- In areas with particularly hard water, limescale may build up on

the components inside the boiler and reduce its overall effi ciency.

C-type boilers, with combustion chambers and air supply circuits

which are completely sealed from the air outside, do not have

any limitations concerning the ventilation and size of the room in

which they are installed.

So that the normal operation of the boiler is not compromised,

the place in which it is installed must be suitable with regard to

the operating limit temperature value and the appliance should

be protected so that it does not come into direct contact with

atmospheric agents.

WARNING

No infl ammable items should be left in the vicinity of

the boiler.

Make sure the installation site and any systems to which

the appliance must be connected are fully compliant

with the current applicable legislation.

If dust and/or aggressive vapours are present in the

room in which it is to be installed, the appliance must

operate independently of the air inside the room.

Minimum clearances

In order to allow easy access for boiler maintenance operations,

installation distance must be suitable.

Position the boiler according to the established technical rules,

using a spirit level.

GENUS PREMIUM EVO HP 45/65

450

GENUS PREMIUM EVO HP 85/100/115/150

450