Aeotec MULTISENSOR 6 Manual - Page 2

Browse online or download pdf Manual for Security Sensors Aeotec MULTISENSOR 6. Aeotec MULTISENSOR 6 10 pages. Z-wave water and flood sensor
Also for Aeotec MULTISENSOR 6: User Manual (13 pages), Manual (3 pages), User Manual (8 pages), User Manual (13 pages)

Print Page
Aeotec MULTISENSOR 6 Manual
1.
Press and hold the Action Button of your Water Sensor 6 for 20 seconds.
2.
Wait until the RGB LED turns into a green or rainbow gradient Color after 20 seconds of holding.
3.
Release the Action Button.
4.
If your Water Sensor 6 has been successfully factory reset, the RGB LED will be active with a colorful gradient for 3 seconds before disappearing. When
you tap the Action Button on Water Sensor, its green LED will blink rapidly. If the factory reset was unsuccessful, the green LED will remain on solid for a
few seconds when you tap the Action Button.
Safety Warning for Batteries
The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of different charging level or different brands.
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the
devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This
controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Inclusion
Short press the products Action Button that you can find on the product.
Exclusion
Short press the products Action Button that you can find on the product.
Product Usage
Optimally placing Water Sensor 6.
The final installation steps of Water Sensor 6 are very simple, all you need to do is choose the area that you want Water Sensor 6 to monitor leaks or floods in.
Water Sensor 6 is optimally placed on a flat surface where floods, leaks and drips can occur; these can include your washroom or kitchen. When placing it, ensure
that its detection probes touch the surface being monitored; when water touches any 2 of the 4 probes on Water Sensor 6 an alert will be sent to your Z-Wave
network. Below are some of the possible situations that can trigger Water Sensor 6.
1. Water is detected by sensing point 2 and 4.
2. Water is detected by sensing point 1 and 3.,
3. Water is detected by sensing point 1 and 2.