Aeotec MultiSensor 7 User Manual - Page 2
Browse online or download pdf User Manual for Security Sensors Aeotec MultiSensor 7. Aeotec MultiSensor 7 5 pages.
Also for Aeotec MultiSensor 7: User Manual (8 pages)
Print Page
Button Functions.
Action button press
1x Tap (when factory reset)
1x Tap (when already paired)
Press and hold [1, 2 seconds)
Press and hold [2, 5 seconds)
Press and hold [5, 9 seconds)
Press and hold [9, 15 seconds)
Press and hold [15, 20 seconds)
Press and hold [20+ seconds)
Important safety information.
LED Status
Function
Pair Mode
Solid
Yellow
Enters Z-Wave pair mode, flashes white/green 4 times within 2 seconds
Sends NIF / Excludes device
Solid
Purple
if Z-Wave controller is in unpair mode, starts
reset successfully.
No LED
N/A
Quick Wakeup
Solid
Red
LED will disappear as soon as you release its button. The MultiSensor 7
wakeup report to your Z-Wave Controller to take in any queued z-wave c
waiting in your controller.
Long Wakeup Mode
LED will remain solid
Solid
Orange
told to sleep by user or z-wave controller). This will allow you to easily co
device while the sensor is used with battery power assuming your Z-Wav
does not queue the command.
Communication Health Test (Direct gateway communication - does not
repeaters).
This will test your MultiSensor 7 direct communication to your Z-Wave C
remain
Solid
Cyan
Once finished it will become a solid color for 2 seconds as
indicate health:
Red
Yellow
Green
Blinking
Red
Release here to cancel Factory Reset.
Blue
fade in/out for 2 seconds. Factory Reset.
Orange
upon release of its button for 5 minutes ma
Cyan
while it is testing.
= Bad health, can't communicate at all.
= Moderate health, could use improvement, some communcation
= Great health
blue