Aeotec Siren 6 User Manual - Page 5
Browse online or download pdf User Manual for Security System Aeotec Siren 6. Aeotec Siren 6 6 pages. Indoor siren
Also for Aeotec Siren 6: Quick Start Manual (7 pages), Quick Start Manual (10 pages)
Print Page
Advanced.
Removing your Siren from a Z-Wave network.
Your Siren can be removed from your Z-Wave network at any time. It is always advised that you use your gateway to
perform an unpair in order to avoid leaving phantom / failed nodes that become difficult to remove. To do so, follow
the steps below:
1. Place your gateway or controller into Z-Wave unpair or exclusion mode. (Please refer to your controller/gateway
manual on how to do this)
2. Press the Action Button 6x times in 2 seconds on your Siren.
3. If your Siren has been successfully unpaired from your network, its LED will begin to blink slowly which
indicates that it is ready to be paired again.
Test Siren 6 sound manually.
You will be able to manually test your Siren 6 unpaired or paired to a Z-Wave network, to determine if its sound is
working, perform the button action listed below:
Press and hold Action Button down for 2-5 seconds
Safety: Test only when wearing necessary ear protection. Siren 6's speaker emits tones up to 105dB that can
cause hearing damage.
Reset your Siren.
This method is not fully advised unless your gateway has failed, and you do not yet have another gateway to perform
a general unpair on Siren 6.
To do this, follow the steps below:
1. Press and hold the Action button for 20 seconds
2. [2-5 seconds], the test siren sound will run, then stop after 5 seconds has passed.
3. [5-20 seconds] The LED will continue to blink faster (5 to 10 seconds) and faster (10 to 20 seconds).
4. [21 seconds and later] The LED will then quickly flash 3 times then will have LED breath in and out as you hold
down the Action Button
5. Release the Action button, and the Siren 6 will factory reset.
Upgrade Siren 6 to Doorbell 6.
You can upgrade Siren 6 to Doorbell 6 at any time, all you need is Aeotec Button which is a wireless addon button
used for Siren/Doorbell 6. Siren 6/Doorbell 6 supports up to 3 Aeotec Buttons.
You can learn how to pair Aeotec Button to Siren 6 here:
https://aeotec.freshdesk.com/solution/articles/6000202225-aeotec-button-user-guide-
(https://aeotec.freshdesk.com/solution/articles/6000202225-aeotec-button-user-guide-)
More Advanced Configurations.