Whirlpool 4GNTW4600 Installation Instructions Manual - Page 6

Browse online or download pdf Installation Instructions Manual for Washer Whirlpool 4GNTW4600. Whirlpool 4GNTW4600 27 pages. Top-loading washer
Also for Whirlpool 4GNTW4600: Installation Instructions Manual (27 pages), Installation Instructions Manual (27 pages), Use And Care Manual (44 pages)

Print Page

CONNECT DRAIN HOSE

Attach

drain

hose to drain

port

Remove the red plastic plug from the black drain port on the

back of the washer.

If clamp is not already in place on elbow end of drain hose,

slide it over end as shown. Squeeze clamp with pliers and

slide black elbow end of drain hose onto black drain port

and secure with clamp.

For a laundry tub or standpipe drain, go to step 6.

For a floor drain, remove the preinstalled drain hose form as

shown in Step 7. You may need additional parts with separate

directions. See "Tools and Parts".

For floor drain installations, you will need to remove the drain

hose form from the end of the drain hose. You may need

additional parts with separate directions. See "Tools and Parts".

CONNECT INLET HOSES

Washer must be connected to water faucets with new inlet

hoses with flat washers (provided). Do not use old hoses.

NOTE: Both hoses must be attached and have water flowing

to inlet valves. If you are only connecting to a cold water

faucet, you must use a Y-adapter (provided).

Place drain

hose in standpipe

Place hose into standpipe (shown in picture) or over side of

laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay on

bottom of laundry tub. Drain hose form must be used.

Attach hose to hot water faucet. Screw on coupling by hand

until it is seated on washer. Use pliers to tighten couplings an

additional two-thirds turn. Repeat this step with second hose

for cold water faucet.

IMPORTANT: Do not overtighten

or use tape or sealants on

valve when attaching to faucets or washer. Damage can result.