Whirlpool 7MWFW87HEDC0 Use & Care Manual - Page 18
Browse online or download pdf Use & Care Manual for Washer Whirlpool 7MWFW87HEDC0. Whirlpool 7MWFW87HEDC0 48 pages.
Print Page
Troubleshooting
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter,
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
tf
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help
=
"_
In Canada www.whirlpool.ca
for assistance and to possibly avoid a service call.
Washer won't run or fill,
washer stops working
18
Check for proper water supply.
Check proper electrical supply.
Normal washer operation.
Solution
Both hoses must be attached and have water flowing to
inlet valve.
Both hot and cold water faucets must be turned on.
Check that inletvalve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into a grounded 3=prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Check electrical source or call an electrician to check if voltage
is low.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Door must be completely
closed and latched for washer to run.
Washer will pause during certain phases of cycle.
Do not interrupt cycle.
The washer pauses for about 2 minutes during certain cycles.
Allow the cycle to continue. Some cycles feature periods of
tumbling and soak.
Washer may be stopped to reduce suds.
Cold Wash uses less water in the beginning of the cycle to
provide a high concentration
of detergent for optimal cleaning
action. Following this concentrated
tumbling, more water is
used to complete the wash.
During the first 20 minutes of the Clean Washer with affresh ®
cycle, it will activate the steamer but the drum will not spin or fill
with water. You may see condensation
on the door glass during
this initial phase. If you are using an affresh ® Washer Cleaner
tablet, it will not dissolve completely
during the steam phase.
This is normal.
The washer door is not firmly shut.
The door must be closed during operation.
Washer not loaded as recommended.
Remove several items, rearrange load evenly in washer drum.
Close door and touch and hold START.
Do not add more than 1 or 2 additional items after cycle has
started to avoid tightly packing or unbalancing.
Do not add more water to the washer.
J