Whirlpool 8212 Instruction Manual

Browse online or download pdf Instruction Manual for Washer Whirlpool 8212. Whirlpool 8212 4 pages.

Print Page

Quick guide

THANK YOU FOR BUYING AN INDESIT PRODUCT.

In order to receive a more complete assistance, please

CONTROL PANEL

ON/OFF Button (hold to Reset)

Programme Selection Knob

Start/Pause

Options Buttons*

Push & GO

Dryness Level

Start Delay

Timed Drying

Cycle End Signal

Light Dry

(hold for Key Lock)

Crease Care (hold to Mute)

INDICATORS

Dryness Level:

Iron Dry -

Program Status:

Drying -

Empty water tank

Refer to troubleshooting section:

FIRST TIME USE

Remove all the tapes used to hold items on the machine.

Before you use it, clean the inside of the drum to remove any

dust that could have accumulated during transport. Slight odour

or vapour may be found if you open the door during its first use,

this is normal and should only last a few minutes.

Make sure that the water tank is correctly inserted. Make sure

that the drain hose on the back of the dryer is properly

connected, either to the dryers's water tank or to your domestic

drainage system.

The dryer must be installed in a room with a temperature

ranging between 5°C and 35°C to ensure proper operation.

DAILY USE

Doing this will keep your machine working at its BEST:

- remember to empty your water tank after each drying cycle.

remember to clean your condenser unit regularly

(monthly).

- remember to clean your filter after each drying cycle.

Refer to the Care & Maintenance section.

1. Plug the dryer into the power supply socket.

2. Open the door and load garments; always refer to instructions on

clothing labels and the max loads indicated in the programme

section. Empty pockets. Make sure garments do not get caught

between the door and/or the door filter. Do not load items that

are dripping wet. Do not tumble dry large, very bulky items.

3. Close the door.

4. Press the "On/Off" button.

5. Select the most suitable programme

load.

6. Select the options, if necessary.

7. Press the

"Start/Pause"

button to begin drying.

8. At the end of the drying cycle, a buzzer will beep. An indicator on

the control panel signals the end of the cycle. Pull the load out

immediately to prevent the formation of creases on laundry.

9. Turn the machine off by pressing the "On/Off" button, open the

door and pull the clothing out. If the machine is not switched off

manually, after about a quarter of an hour from the end of the

cycle , the appliance turns off automatically to save energy.

Note that some programme/option accords with "Crease Care"

system. This means that for some hours, after the end of the

drying cycle, the drum rotates at regular intervals to prevent the

formation of creases.

In case of power failure, it is necessary to press the "Start/Pause"

button to restart the cycle.

Hanger Dry -

Cupboard Dry -

Cool Down - END End of Cycle

Clean door filter -

Clean the condenser unit

Failure:

Call after sales service.

for the type of fabric in that

Before using the appliance carefully read the Safety

Instructions.

END

h h

Extra Dry

PUSH & GO

This function allows you to start an automatic drying cycle with just a

few simple gestures.

It is always necessary to follow points 1, 2, 3 and 4 of the "Daily

Use" section.

Press and hold the "Push & Go" button after turning on the machine,

regardless of the position of the knob. The light on indicates that

the cycle has started. This programme does not allow setting other

options.

This cycle is suitable for cotton and synthetic items, max load 4 kg

(cycle duration 100').

OPENING THE DOOR DURING THE CYCLE

Laundry can be checked while the drying cycle runs and any

garments already dry can be removed, while drying continues for

the remaining items. After closing the door, press the "Start/Pause"

button to resume machine operation.

TRANSPORT AND HANDLING

Never lift the dryer by holding on to its top side.

1. Unplug the dryer

2. Remove the water from the water tank completely.

3. Make sure that door and water tank are properly closed.

4. If the drain hose is connected to your drainage system, re-connect

it to the back of the dryer (see "Installation" section in the Safety

Instructions).

CARE LABEL

Always check the care labels, especially when placing garments

in the tumble dryer for the fi rst time. Below are the most

commonly used symbols:

May be tumble dried.

Do not tumble dry.

Tumble dry – high heat.

Tumble dry – low heat.