Whirlpool 8212638RP Owner's Manual Manual - Page 9

Browse online or download pdf Owner's Manual Manual for Washer Whirlpool 8212638RP. Whirlpool 8212638RP 29 pages.

Print Page

Available accessories:

An optional matching pedestal is available for your machine.

Please contact your retailer for ordering information, or see the

"Assistance or Service" on Quick Start Guide.

Alternate parts (not supplied with machine):

Your installation may require additional parts. To order, please

refer to toll-free numbers on Quick Start Guide.

If you have:

Overhead sewer

Alternate inlet hoses (may be required for some installations, not

supplied with machine):

� 8212656RP

� 8212641RP

� 8212546RP

� 8212545RP

� 8212487RP

� 8212638RP

Location Requirements

Proper installation is your responsibility.

You will need:

� A water heater set to 120°F (49°C).

� A grounded electrical outlet located within 6 ft (1.8 m) of power

cord on back of machine.

� Hot and cold water faucets located within 4 ft (1.2 m) of hot

and cold water fill valves on machine, and water pressure of

20 psi–100 psi (137.9 kPa–689.6 kPa).

� A level floor with maximum slope of 1" (25 mm) under entire

machine. Installing on carpet or surfaces with foam backing is

not recommended.

� Floor must support machine's total weight (with water and

load) of 315 lb (143 kg).

IMPORTANT: Do not install, store, or operate machine where it

will be exposed to weather or in temperatures below 32°F (0°C).

Water remaining in machine after use may cause damage in low

temperatures. See "All-In-One Washer & Dryer Care" for

winterizing information.

You will need:

Standard 20 gallon (76 L) 39"

(990 mm) tall drain tub or utility

sink, sump pump and

connectors (available from local

plumbing suppliers)

10 ft (3.0 m) Inlet hose, Black

EPDM (2 pack)

5 ft (1.5 m) Inlet hose, Black

EPDM (2 pack)

4 ft (1.2 m) Inlet hose, Black

EPDM (2 pack)

5 ft (1.5 m) Inlet hose, Red and

Blue EPDM (2 pack)

5 ft (1.5 m) Nylon braided inlet

hose (2 pack)

6 ft (1.8 m) Nylon braided inlet

hose, space-saving 90° elbow,

hypro-blue steel couplings

(2 pack)

Whirlpool

Models*

*For additional details (or information) specific to your model, refer

to the 'Dimensions' listed for your model at www.whirlpool.com.

Custom under-counter installation:

(25 mm)

Recessed area or closet installation:

(76 mm)

48 in

(310 cm

)

24 in

(155 cm

)

(76 mm)

0.25"

(5 mm)

39"

(991 mm)

minimum

(25 mm)

27"

(686 mm)

(25 mm)