Whirlpool ATW4475V User Instructions - Page 8

Browse online or download pdf User Instructions for Washer Whirlpool ATW4475V. Whirlpool ATW4475V 20 pages. Whirlpool atw4475v: user guide

Print Page

Washer won't run, fill, rinse, or agitate; washer stops

Is the power cord plugged into a grounded 3 prong

■

outlet? Plug power cord into a grounded 3 prong outlet.

Are you using an extension cord?

■

cord.

Is the indicator on the Timer knob properly lined up with a

■

cycle? Turn the Timer knob to the right slightly and pull knob

out to start.

Are the water inlet valve screens clogged?

■

water and remove inlet hoses from the washer. Remove any

accumulated film or particles. Reinstall hoses, turn on water,

and check for leaks.

Are both the hot and cold water faucets turned on?

■

Turn on the water.

Is the water inlet hose kinked?

■

Has a household fuse blown, or has a circuit breaker

■

tripped? Replace the fuse or reset the circuit breaker. If the

problem continues, call an electrician.

Is the washer in a normal pause in the cycle?

■

pauses for about 2 minutes during certain cycles. Allow the

cycle to continue. Some cycles feature periods of agitation

and soak.

Is the washer overloaded?

■

Is the lid open?

The lid must be closed during operation.

■

Washer will not agitate or spin with the lid open.

Do not use an extension

Turn off the

Straighten the hoses.

The washer

Wash smaller loads.

Washer won't drain or spin, or loads are wet

Is the drain hose clogged, or the end of the drain hose

■

more than 96" (2.4 m) above the floor? See the Installation

Instructions for proper installation of drain hose.

Is the lid open?

The lid must be closed during operation.

■

Washer will not agitate or spin with the lid open.

Is there excessive sudsing?

■

Follow manufacturer's directions. If you have very soft water,

you might need to use less detergent.

Did you use the right cycle for the load being washed?

■

Select a cycle with a higher spin speed (if available).

Is the drain hose length fed too far down the drain pipe?

■

Use the drain hose form to raise the end of the hose. The

hose should be no more than 4.5" (113 mm) down the pipe.

Secure drain hose to drain pipe.

Washer continues to fill or drain; cycle seems stuck

Is the top of drain hose lower than the water level in

■

washer? The top of the hose must be higher than the water

level in the washer for proper operation. See the Installation

Instructions.

Does the drain hose fit too tightly in the standpipe, or is it

■

taped to the standpipe? The drain hose should be loose yet

fit securely. Do not seal the drain hose with tape. The hose

needs an air gap. See the Installation Instructions.

Wash/Rinse temperature not what I selected

Are the hot and cold water inlet hoses reversed?

■

Installation Instructions for more information.

Does the Hot or Warm wash seem cooler than you

■

expected? Hot and warm temperatures are controlled by the

washer and may be cooler than your previous washer. This is

normal. The cooler temperatures save energy while providing

good cleaning.

Garments damaged

Check the following:

Empty pockets, zip zippers, snap

■

or hook fasteners before washing. Tie strings and sashes

to avoid tangling. Were items damaged before washing?

Mend rips and broken threads in seams before washing.

Always measure detergent.

See the