Whirlpool AWE 9727 Manual - Page 4
Browse online or download pdf Manual for Washer Whirlpool AWE 9727. Whirlpool AWE 9727 4 pages.
Print PageCONSUMPTION DATA
Temperature
Programme
(°C)
95
Cotton
Cotton
60
Cotton with "Eco +"***
60
Cotton
40
Synthetics
60
Synthetics
40
Daily load
40
Quick wash
30
Delicates
40
Baby
40
Lingerie
30
Wool
40
Handwash
40
Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home
may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
*
The time indicated on the display can deviate from the values in the table, because it takes into account the household
conditions applicable at that time.
**
To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
***
Reference Programme for Energy Label.
ADD DETERGENTS, CLOSE THE LID AND
SELECT THE PROGRAMME
Add detergent as indicated on the front page and as
described in the chapter "Detergent and Additives"
in your Instructions for Use.
1. Turn the programme selector to the desired
programme.
2. The temperature and spin speed indicated on
the display can be altered by pressing the
"Temperature" button
or the "Variable
spin" button
. The light next to the "Start
(Pause)" button flashes.
SELECT ANY DESIRED OPTION
When the combination of programme and additional
option(s) is not possible, the indication lights switch off
automatically. Unsuitable combinations of options are
deselected automatically.
"Prewash" button
• Only for heavily soiled loads (for example sand,
granular dirt) sensible. Increases the cycle time
by approximately 15 min.
• Do not use liquid detergent for the main wash
when activating the Prewash option.
"Eco +" button
• With a modified temperature profile and a slightly
prolonged washing duration, the optimum
combination of excellent washing result and even
lower energy consumption is achieved.
"Intensive rinse" button
• More water is added and rinse cycle is prolonged.
• This option is particularly suitable for areas with
very soft water or for washing baby linen, and
helps people with allergies.
Load
Water
Energy
Approx. Programme Duration
(kg)
(l)
(kWh)
(hours : minutes)*
5.5
55**
1.70
1:55
5.5
49
1.02
2:25
5.5
49
0.93
2:35
5.5
53
0.55
2:00
2.5
53**
0.85
1:30
2.5
47
0.50
1:15
3.0
43
0.48
1:00
3.0
36
0.30
0:30
1.5
51
0.50
0:45
5.5
73
0.55
2:15
1.0
42
0.30
0:31
1.0
53
0.50
0:45
1.0
43
0.50
0:35
"Rinse hold" button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to avoid
creasing and prevent colours from changing.
• This option is particularly recommended for the
programmes "Synthetics", "Daily load" and
"Delicates".
• It is particularly useful if you want to postpone
spinning to a later time, or if you want to drain only.
• If you select "Rinse hold", do not leave the laundry
to soak for too long.
Note: The programme stops to "Rinse hold" at
the time the "Rinse hold" lights up on the display.
The light next to the "Start (Pause)" button
flashes.
Terminate the "Rinse hold" option:
• Press the "Start (Pause)" button; the
programme will terminate automatically with the
final spin cycle for the present wash programme.
• If you do not wish to spin the clothes, turn the
programme selector to "Drain"
the "Start (Pause)" button to start the Drain
programme.
"Easy ironing" button
• Can be used together with "Cotton", "Synthetics"
and "Daily load" programmes to make ironing easier.
• Increases the water quantity and the clothes are
spun very gently.
"Variable spin" button
• Every programme has a predefined spin speed.
• Press the button to set another spin speed.
• If spin speed "0" is selected, the final spinning is
cancelled but intermediate spin peaks remain
during rinse. The water is drained out only.
SAVE YOUR FAVORITES PROGRAMMES
If there is a programme setting which you use
frequently, the appliance offers the possibility to
save one setting for each programme so that it can
be used again by just pushing one button.
• Select the desired programme, temperature, spin
speed and option(s), push and hold the
"Favorites" button for at least 3 seconds. The
lamp next to "Favorites" shortly flashes and then
lights up - the programme setting is saved.
Next time you want to use your individual
programme setting, select the programme, push the
"Favorites" button and start by pushing "Start
(Pause)".
If you want to replace the saved programme
setting by another one:
• Select the desired programme, temperature,
spin speed and options and then press and hold
the "Favorites" button for at least 3 seconds.
The previously saved programme setting will be
replaced by the new one.
START DELAY
The "Start Delay"
allows to run the machine at
the consumer's convenience, for example at night
when electricity is cheaper.
• Select programme, temperature, spin speed and
options.
• Press the "Start Delay" button to select the delay
time up to 23 hours.
• Press the "Start (Pause)" button.
The countdown of the delay time begins; the clock
symbol next to the delay time and the dot between
hours and minutes flash.
• The time delay indication disappears when the
programme starts and it is replaced by the
remaining programme time.
• Once having pressed the "Start (Pause)"
button, the number of hours preselected can be
reduced by pressing and holding the "Start
Delay" button. From 1 hour on, the delay time
can also be reduced by minutes.
To cancel the "Start Delay"
..before you press the "Start (Pause)" button:
• Select another programme or press the
"Reset" button.
and press
..after having pressed the "Start (Pause)"
button:
• Press the "Reset" button for at least 3 seconds -
the start delay time disappears from the display.
PROGRAMME START
Open the tap and press the "Start (Pause)" button.
The light next to the "Start (Pause)" button is on.
The programme sequence indicator shows the
current programme phase, running from left to right
through Wash, Rinse, Spin/Drain.
"DOOR OPEN" INDICATION
Before starting and after end of a programme, the
symbol lights to show that the lid can be opened. As
long as a wash programme is running, the lid
remains locked and must on no account be forced
open. In case you have an urgent need to open it
during a running programme, refer to "Cancel
(Reset) a running programme before the end".
LOCK BUTTONS
You can lock the buttons of the control panel against
improper use (e.g. by children).
• Press the temperature and the spin speed button
simultaneously and hold them for at least 3
seconds. The key symbol on the display lights up.
• T o unlock the buttons again: proceed in the same way.
RED INDICATIONS ON THE DISPLAY
"Water tap closed"
The appliance has no or insufficient water supply.
Open the water tap; if the indication still lights up,
refer to the "Troubleshooting Guide" in the
Instructions for Use.
"Clean pump"
Waste water is not pumped out. Check whether the
drain hose is kinked or the filter must be cleaned; in
the latter case refer to the Instructions for Use
("Removing the Filter").
"Service"
Lighting up of the "Service" indication can be caused by
a fault in an electrical component. Refer to the
"Troubleshooting Guide" in your Instructions for Use; if
the fault persists, contact our After Sales Service.
PROGRAMME END
• The symbols of the programme sequence
indicator are dark, and the "Door open"
symbol
lights up.
1. Turn the programme selector to the "Off/O" position.
2. Close the water tap.
3. Open lid and drum and unload the machine.
4. Leave the lid open to allow the inside of the
machine to dry.
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
1. Press the "Start (Pause)" button to pause the
programme. The light flashes.
2. Select the new programme, temperature, any
options and another spin speed if you want.
3. Press the "Start (Pause)" button again. The
new programme continues at the same position
where the previous programme was interrupted.
Do not add detergent for this programme.
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
The "Reset" button cancels a programme before
the end.
• Press the "Reset" button for at least 3
seconds. Any existing water is drained out
before the lid can be opened.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10631