Whirlpool AWM 1000 Programme Chart - Page 2

Browse online or download pdf Programme Chart for Washer Whirlpool AWM 1000. Whirlpool AWM 1000 2 pages.

Print Page

1
2

CONSUMPTION DATA

Temperature

Programme

Selector

(°C)

Cotton / Antibacterial

95

Colours***

60

Colours

60

Colours

40

Synthetics

40

Daily load

40

Rapid plus

30

Delicate

30

Wool

40

Handwash

30

Big items

40

Prewash cycle increases programme duration by approximately 15 min. Consumption values were measured in normalized conditions in

compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the

water supply pressure and temperature, the load and the type of wash.

*

The remaining time indicator can deviate from the values in the table, because it takes into account the operating conditions

applicable at that time.

**

To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

*** Reference programme for energy label.

ADD DETERGENT, CLOSE THE DOOR

AND SELECT THE PROGRAMME

Add the detergent as described in the programme

table or in the chapter "Detergent and Additives" of

the Instructions for Use.

1. Turn the programme selector to the desired

programme.

2. The remaining time display shows the duration

of the chosen programme (in hours and

minutes) and the lamp of the "Start/Pause"

button

flashes.

3. The indicator of the predefined spin speed

corresponding to the selected programme lights

up; it can be altered by pressing the "Variable

spin" button. The recommended temperature

(see indicator) can be altered by pressing the

"+" or "–" button.

SELECT ANY DESIRED OPTION

Selecting any option the indication lights up.

When the combination of programme,

additional options and temperature is not

possible, the indication lights switch off

automatically and a signal sounds.

"Easy ironing" button

• Can be selected to reduce creasing.

• Increases the water quantity and the clothes are

spun very gently.

Load

Water

Energy

Approximate programme

duration*

(kg)

(l)

(kWh)

(hours : minutes)

10.0

99**

3.15

2:45

10.0

92

1.70

2:45

4.0

50

1.10

1:35

10.0

92

0.96

2:35

4.5

58

0.65

1:30

4.5

58

0.65

1:00

4.5

38

0.40

0:30

3.0

70

0.45

0:50

2.0

60

0.50

0:35

2.5

60

0.30

0:31

3.0

85

0.80

1:30

"Prewash" button

• Only for heavily soiled laundry (e.g. sand,

granular dirt). The cycle time increases by

approx. 15 minutes.

• Do not use liquid detergent for the main wash

when activating the "Prewash" button.

"Extra rinse" button

• More water and a longer time in rinse cycle is

added.

• This option is particularly suitable for areas with

very soft water, for baby clothes and to help

people with allergies.

"Rinse hold" button

• The laundry remains in the last rinse water

without being spun: this prevents creasing and

colours from changing.

• This option is particularly recommended for the

programme "Synthetics" or "Delicate".

• It is particularly useful if you want to postpone

spinning to a later time, or if you want to drain

only.

Note: The programme stops to "Rinse hold" as

soon as the "Rinse hold" light in the programme

sequence indicator lights up.

Terminate the "Rinse hold" option

• Press the "Rinse hold" button again; the

programme will terminate automatically with the

final spin cycle for the present wash programme.

• If you do not wish to spin the clothes, press the

"Reset/Unlock door" button. The water is

drained out then, before the door can be opened.

"Variable spin" button

• Every programme has an automatic predefined

spin speed.

• Press the button to set another spin speed.

• If spin speed "0" is selected, the final spinning is

cancelled but intermediate spin peaks remain

during rinse. The water is drained out only.

START DELAY

The "Start delay" allows to run the machine at the

consumer's convenience, for example at night when

electricity is cheaper. Do not use liquid detergent

when activating the "Start delay".

• Select programme, temperature and options.

• Press the "Start delay" button to select the delay

time by 1 to 23 hours;

• Press the "Start/Pause" button

• The time delay indication disappears when the

programme starts and it is replaced by the

remaining time.

• The number of hours preselected can later be

reduced pressing again the "Start delay" button.

To cancel the "Start delay"

• Turn the programme selector to the " " position.

• Reselect the desired programme and options

and press the "Start/Pause" button

PROGRAMME START

Turn on the tap and press the "Start/Pause"

button

. The pilot lamp of the "Start/Pause"

button

lights up.

The indicator lamps show the sequence reached in

the programme. After starting the programme, the

sequence indication runs from top to bottom

through Prewash, Wash, Rinse, Spin.

When a sequence of the programme is finished the

corresponding lamp goes out.

ADD WASHING/DOOR LOCK

Each time a programme starts the door is locked, the

"Door locked" indication light comes on and approx.

0.5 litres of water enters the machine. In the

programmes Cotton / Antibacterial, Colours,

Synthetics, Daily load and Rapid plus, for 10 minutes at

the beginning of the Main Wash the programme can be

interrupted by pressing the "Start/Pause" button

and the door can be opened again, e.g. to add more

:

washing. After this time, the door remains locked until

the end of the programme and must on no account be

forced open. You will find more information about

door locking in the Instructions for Use.

PROGRAMME END

• The time remaining is "0:00" and the "End" light

is on.

1. Turn the programme selector knob to the "

position.

2. Turn the tap off and leave the door ajar to allow

the drum to dry.

CHANGE THE PROGRAMME,

TEMPERATURE, OPTIONS AFTER

PROGRAMME START

1. Press the "Start/Pause" button

interrupt the programme. The light flashes.

2. Select the new programme (with temperature),

any options and another spin speed if you want.

3. Press the "Start/Pause" button

new programme continues at the same position

where the previous programme was interrupted.

Do not add detergent for this programme.

.

CANCEL (RESET) A RUNNING

PROGRAMME BEFORE THE END

Press the "Reset/Unlock door" button

least 3 seconds. Any existing water is drained out

before the door can be opened. Caution, the

washing could still be hot!

.

CHILD LOCK

Detailed information can be found in the

instructions for use.

.

The controls can be locked to avoid interference by

children.

1. If the machine is off:

Turn the programme selector knob from the

OFF position "

" to any programme. Do not

press the "Start/Pause" button

"Child lock" button for 5 seconds. The "Child

lock" indicator lights up. Turn the programme

selector knob to the OFF position "

2. While a programme is running:

Press the "Child lock" button

seconds. The child lock indicator will light up.

Now, in spite of the programme selector knob being

turned, no programme can be started or altered.

However, a running programme can be stopped at

any time (e.g. in an emergency), by turning the

programme selector knob to "

changing during the running programme are signalled

by the lamp of the accidentally chosen programme

flashing. The indicator light for the actual programme

running is on.

To unlock the controls, the machine must either have

a programme running or be in select mode. Press the

"Child lock" button

lock lamp will go out.

Whirlpool is a registered trademark of Whirlpool USA

"

to

again. The

for at

. Press the

" again.

for 5

". Attempts at

for 5 seconds. The child

5019 301 15195

1
2