Whirlpool AWM 8712 Instructions For Use Manual - Page 13

Browse online or download pdf Instructions For Use Manual for Washer Whirlpool AWM 8712. Whirlpool AWM 8712 15 pages.

Print Page

Red indication

Indication on display

lights up

from "F02" to "F35"

from "F40" to "F43"

"Service"

"Electrical module fault"

(except "F24")

Push the "Reset" button for at least 3 seconds.

"Electrical module fault"

Make sure that the water tap is open. If yes:

• Switch the washing machine off by turning the

programme selector to the "Off/O" position; then

turn the programme selector to a wash

programme again. If there is still a failure:

• Push the "Reset" button for at least 3 seconds.

"F24"

"Water level too high" (after programme

cancellation or false operating). Switch off the

washing machine by turning the programme selector

to the "Off/O" position. Turn the programme

selector to a wash programme again, shortly press

the "Reset/Drain" button and press "Start /Pause"

within 15 seconds to start the Drain programme.

"F02" or "FA"

"Waterstop fault"

Turn the programme selector to the "Off/O"

position, pull out the mains plug and turn the water

tap off. Tilt the appliance forward carefully to allow

collected water to flow out from the bottom. Then:

• Plug in the appliance again.

• Turn the water tap on (if water immediately flows

into the appliance without the appliance being

started, there is a failure; turn off the tap and notify

the After-Sales Service).

• Select and start the desired programme again.

"Fod"

"Overfoaming"

Too much foam interrupted the wash programme.

• Select and start the "Rinse & Spin" programme.

• Afterwards select and start the desired

programme again, using less detergent.

If any of the faults described above persist,

unplug the appliance, turn off the water tap

and contact our After-Sales Service (see next

chapter).

GB 12

Description

Causes

Solutions