Whirlpool 2300257 Use And Care Manual - Page 9
Browse online or download pdf Use And Care Manual for Refrigerator Whirlpool 2300257. Whirlpool 2300257 36 pages. Bottom-mount refrigerator
Print PageAdjust the Doors
Door Closing
Your refrigerator has two front adjustable rollers which are at the
base of the refrigerator on either side. If your refrigerator seems
unsteady or you want the doors to close easier, adjust the
refrigerator's tilt using the instructions below:
1. Plug into a grounded three prong outlet.
2. Move the refrigerator into its final location.
3. Remove the base grille. Grasp the grille firmly and pull
outward to unclip.
4. Remove the bracket cover. Insert the eraser end of a pencil in
the cover notch. Apply slight downward pressure to the
notched side of the leveling cover while swinging the cover
off.
5. Use a screwdriver or
" hex driver to adjust the roller
adjustment screws. Turn the roller adjustment screw to the
right to raise that side of the refrigerator or turn the roller
adjustment screw to the left to lower that side. It may take
several turns of the roller adjustment screws to adjust the tilt
of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the roller adjustment
screws and rollers. This makes it easier to adjust the screws.
A
A. Roller adjustment screw
B. Stabilizing foot
6. Open both doors again and check to make sure that they
close as easily as you like. If not, tilt the refrigerator slightly
more to the rear by turning both roller adjustment screws to
the right. It may take several more turns, and you should turn
both roller adjustment screws the same amount.
7. Lower the stabilizing foot by turning it clockwise until it is
firmly against floor.
NOTE: Drawer freezer models have a stabilizing foot on each
side which must be lowered by turning clockwise.
8. Replace the bracket cover. Place the bracket cover into the
outer edge, swing the cover toward the cabinet and snap it
into place.
9. Replace the base grille.
Your new refrigerator may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the floor, walls, and cabinets, can make the
sounds seem louder. The following describes the kinds of sounds
and what may be making them.
If your refrigerator is equipped with an ice maker, you will hear
a buzzing sound when the water valve opens to fill the ice
maker for each cycle.
Your refrigerator is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
You may hear the evaporator fan motor circulating air through
the refrigerator and freezer compartments. The fan speed
may increase as you open the doors or add warm food.
Rattling noises may come from the flow of refrigerant, the
water line, or items stored on top of the refrigerator.
Water dripping on the defrost heater during a defrost cycle
may cause a sizzling sound.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your refrigerator.
Contraction and expansion of the inside walls may cause a
popping noise.
You may hear air being forced over the condenser by the
condenser fan.
You may hear water running into the drain pan during the
defrost cycle.
In order to ensure proper temperatures, you need to permit
airflow between the refrigerator and freezer sections. As shown in
the illustration, cool air enters the freezer section through vents in
the rear and top. The air flows forward through the freezer section
and recirculates under the freezer floor. Cool air enters the
refrigerator section through the top, flows down and across
shelves to the doors and recirculates to return air vents at the
bottom.
B
Normal Sounds
REFRIGERATOR USE
Ensuring Proper Air Circulation
9