Whirlpool 3WSC19D4XD00 User Instructions - Page 12

Browse online or download pdf User Instructions for Refrigerator Whirlpool 3WSC19D4XD00. Whirlpool 3WSC19D4XD00 24 pages.

Print Page

Complete the Installation

WARNING

Electrical Shock Hazard

Plug into a grounded (earthed) outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

1. Plug into a grounded (earthed) outlet.

2. Flush the water system. See "Prepare the Water System" or

"Water and Ice Dispensers."

NOTE: Allow 24 hours to produce the first batch of ice. Allow

3 days to completely fill ice container.

Install Air Filter

(on some models)

On some models, your refrigerator's accessory packet includes

an air filter, which must be installed prior to use. On some models,

the air filter is already installed at the factory.

The air filter reduces the buildup of odors. This helps to maintain a

cleaner environment inside the refrigerator.

Installing the Air Filter (on some models)

The filter should be installed behind the vented door along the rear

interior wall at the top of the refrigerator compartment.

1. Remove the air filter from its packaging.

2. Lift open the vented door.

3. Snap the filter into place.

Replacing the Air Filter

The disposable air filter should be replaced every 6 months. The

refrigerator has a status indicator to help remind you when to

replace the filter. See "Using the Controls" for more information.

To order a replacement air filter, see "Accessories."

1. Remove the old air filter by squeezing in on the side tabs.

2. Install the new air filter using the instructions in the previous

section.

REFRIGERATOR USE

Using the Controls

The refrigerator and freezer controls are located on the panel on

the front of the freezer door.

IMPORTANT: The display screen on the control panel will

automatically dim and enter "sleep" mode when both doors have

been closed and the control buttons and (on some models) the

dispenser pad have not been used for 2 minutes or more. While in

"sleep" mode, the first press of a control button will only reactivate

the display screen, without changing any settings. After

reactivation, changes to any settings can then be made. If no

changes are made within 2 minutes, the display will re-enter

"sleep" mode.

Open either door or touch any button on the control panel to

activate the display screen. The home screen will appear as

shown.

On models with a dispenser:

On models without a dispenser:

Adjusting the Controls

For your convenience, your refrigerator and freezer controls are

preset at the factory. When you first install your refrigerator, make

sure that the controls are still set to the default settings. The

factory recommended set points are 4°C for the refrigerator and

-18°C for the freezer.

IMPORTANT:

Wait 24 hours before you put food into the refrigerator. If you

add food before the refrigerator has cooled completely, your

food may spoil.

NOTE: Adjusting the set points to a colder setting will not cool

the compartments any faster.

If the temperature is too warm or too cold in the refrigerator or

freezer, first check the air vents to be sure they are not

blocked before adjusting the controls.