Whirlpool 471 Instructions For Use Manual - Page 9
Browse online or download pdf Instructions For Use Manual for Refrigerator Whirlpool 471. Whirlpool 471 11 pages.
Print Page
AFTER-SALES SERVICE
Before calling After-sales Service:
1. See if you can solve the problem yourself with the
help of the Troubleshooting Guide.
2. Switch the appliance on again to see if the
problem persists. If it does, switch off and wait for
about an hour before switching on.
3. If the problem persists after this action, contact
After-sales Service.
INSTALLATION
• Install the appliance away from heat sources.
Installation in a hot environment, direct exposure
to the sun or installation near heat sources
(heaters, radiators, cookers) will increase power
consumption and should therefore be avoided.
• If this is not possible, the following minimum
distances must be respected:
•30 cm from coal or paraffin stoves;
•3 cm from electric or gas cookers.
• Install the appliance in a dry, well-ventilated place.
• Clean the interior (see the relative heading in this
handbook).
• Fit the accessories.
Specify:
•the nature of the fault,
•the model,
•the service number (the number after the word
SERVICE on the rating plate on the inside of the
appliance),
•your full address,
•your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
Electrical connection
• Electrical connections must be made in
accordance with local regulations.
• Voltage and power consumption are indicated on
the rating plate inside the appliance.
• The appliance must be earthed by law.
The manufacturer declines all liability for
injury to persons or animals and for damage
to property resulting from failure to observe
the above prescriptions.
• If the plug and socket are not of the same type,
have the socket replaced by a qualified electrician.
• Do not use extension leads or adaptors.
Disconnecting the appliance
It must be possible to disconnect the appliance by
unplugging it or by means of a two-pole switch fitted
upline of the socket.
83