Ariston TCL73XS Use And Installation Manual - Page 13
Browse online or download pdf Use And Installation Manual for Dryer Ariston TCL73XS. Ariston TCL73XS 44 pages.
Also for Ariston TCL73XS: Care, Use And Installation Booklet (44 pages)
Print Page
Troubleshooting
Before you call our Customer Care Department, go through the following troubleshooting suggestions:
Problem:
The dryer won't start.
Drying cycle will not begin.
Its taking a long time to dry.
The Option lights and the
Start/Pause light flash amber.
Programme finishes and
clothes are damper than
expected.
If you still have a problem call our Customer Care Department on: 1 877 356 0766
Spare Parts
This dryer is a complex machine. Repairing it yourself or having a non-authorized person try to repair it could
cause harm to one or more persons and to the machine, and could invalidate the spare parts warranty.
Call an authorized service center if you experience problems while using the machine.
Contact number: 1 877 356 0766
Possible causes / Solution:
The plug is not plugged into the socket, or not making contact.
There has been a power outage.
The fuse has blown.
The door is not closed securely?
The PROGRAMS knob has not been set properly (see Start and Programs).
The Start/Pause button has not been pressed (see Start and Programs).
You have set a delayed time (see Start and Programs).
The filter has not been cleaned (see Maintenance).
The temperature setting is not ideal for the type of fabric you are drying
(see Start and Programs and see Laundry).
The condenser needs cleaning (see Maintenance).
The correct drying time has not been selected for the load (see Laundry).
The air intake grille or rear vents are obstructed (see Installation and see
Maintenance).
The items were too wet (see Laundry).
The dryer was overloaded (see Laundry).
If the Option lights and the Start/Pause light flash together with the
Clean Condenser and Cool Tumble lights; Or the Progress lights and
Start/Pause light flash together with the Clean Filter, Clean Condenser,
Cool Tumble and End lights on, then:
- Turn off and remove the plug. Clean the filter and the condenser
(see Maintenance). Then replace the plug, turn on and start another
program. If the same combination of lights still flash contact our
Customer Care Department.
If the Option lights and the Start/Pause light flash with any other
combination of lights on: Note down the lights that are on and contact our
Customer Care Department.
! For safety the dryer has a maximum program time of 3 hours. If an
automatic program has not sensed the required final moisture in this time
the dryer will complete the program and stop. Check the above points and
run the program again, if the results are still damp, contact our Customer
Care Department.
EN
13