Clam 10128 Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Automobile Accessories Clam 10128. Clam 10128 2 pages. For: x200 / x400

Print Page

QTY.

PART NO.

104926

104966

101550

102516

101548

101549

1. Position the strips on the base. Using a 3/16" or slightly larger drill bit, drill a hole through the base

using existing holes in the runner strip starting at the curved end of the base.

2. Slightly tighten fasteners to hold the strip in place so that you may then bend the runner around the

curved area before drilling the next hole

(If you have trouble bending the Wear Strip to the contour of the base, use a heat gun or hair dryer to

make the Strips more pliable before drilling.)

( Also, apply a small amount of grease to threads of screw to prevent seizing of threads.)

3. Drill next hole through the base and slightly tighten fastener to hold the runner in place.

4. Keep repeating this procedure for remaining holes and securely tighten all fasteners when they

are all installed.

5 . Repeat same process for remaining runners.

START HERE

PARTS LIST

DESCRIPTION

RUNNER, .50 X 1.50 X 58 LG

INSTRUCTION, RUNNER KIT, X200/X400

KIT, HARDWARE RUNNER

SCREW,10-24 X 1" PTHMSSS

NUT, 10-24 NYLOCK SS

WASHER, #10 FENDER SS

Runner Kit Installation

(includes the following)