Whirlpool 27" W10563341A Installation Instructions Manual - Page 6
Browse online or download pdf Installation Instructions Manual for Dryer Whirlpool 27" W10563341A. Whirlpool 27" W10563341A 20 pages. Electric dryer 27" wide models
Print Page
INSTALL LEVELING LEGS
1.
Prepare dryer for leveling legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2.
Screw in leveling legs
diamond
marking
Examine leveling legs, find diamond marking. Screw legs into
leg holes by hand, use a wrench to finish turning legs until
diamond marking is no longer visible.
Now stand the dryer on its feet. Slide the dryer until it is
close to its final location. Leave enough room for electrical
connection and to connect the exhaust vent.
6
ELECTRICAL CONNECTION
Power Supply Cord
Electrical Connection Options
1.
Choose electrical connection type
Power supply cord 4-wire receptacle
(NEMA Type 14-30R): Go to 4-wire
Power Supply Cord Connection section.
Then, go to Venting Requirements.
Power supply cord 3-wire receptacle
(NEMA Type 10-30R): Go to 3-wire
Power Supply Cord Connection section.
Then go to Venting Requirements.
4-wire direct connection: Go to 4-wire
Direct Wire Connection section. Then go
to Venting Requirements.
3-wire direct connection: Go to 3-wire
Direct Wire Connection section. Then go
to Venting Requirements.
NOTE:
If local codes do not permit connection of a
cabinet-ground conductor to neutral wire, go to "Optional
3-wire Connection" section. This connection may be
used with either a power supply cord or a direct wire
connection.