Whirlpool 27' Job Aid - Page 24

Print Page

Removing the Dryer Door

1. Remove the toe panel.

2. Pull down and unhook and remove the left and right door springs. (Fig. 36)

3. Open dryer door. Remove the screws from each door hinge. (Fig. 37) Remove dryer door by

sliding it off of hinges.

4. Slide new door onto hinges. Align screw holes in hinges. Reinstall hinge screws into new

dryer

door. Close dryer door.

5. Hook long, skinny end of door spring into left hinge. Pulling down on spring, hook other end

into bottom front of cabinet. Repeat with other spring.

6. Snap toe panel into place.

Fig. 36

1. Remove the dryer top.

2. Remove the toe panel.

3. Remove the lint screen.

4. Release the two (2) door springs.

5. Remove the two screws attaching

the lint duct to the dryer and remove the lint duct.

6. Remove the two (2) screws at the bottom and the

two (2) screws at the top of the front panel. (Fig. 38)

7. Pull wiring harness out of clips inside top side of dryer.

Disconnect the wiring harness. (Fig. 39)

8. Lift up and remove front panel. (Fig. 40)

Fig. 39

Fig. 37

Fig. 38

Fig. 40