Whirlpool 3XWGD5705 Installation Instructions Manual - Page 10

Browse online or download pdf Installation Instructions Manual for Dryer Whirlpool 3XWGD5705. Whirlpool 3XWGD5705 36 pages. Electric and gas dryer
Also for Whirlpool 3XWGD5705: Use & Care Manual (36 pages), Use & Care Manual (40 pages)

Print Page

Level and Exhaust the Dryer

Dryer must be level to reduce noise and assure proper

performance.

Slide dryer onto cardboard or hardboard before moving across

floor to prevent floor damage.

1. Move dryer close to its permanent location. Leave enough

room to connect exhaust vent. Remove cardboard or

hardboard from under dryer.

2. Check levelness of dryer by placing a level on top of dryer,

first side to side, then front to back. If dryer is not level, adjust

dryer legs up or down.

3. If legs are not long enough to level dryer, order Extended

Dryer Feet Kit, Part No. 279810 (sold two legs per kit), from

your dealer.

4. Connect exhaust vent to exhaust outlet in dryer. The exhaust

vent must fit over the dryer exhaust outlet and inside the

exhaust hood vent. Use 102 mm (4") vent clamps to seal all

joints and to secure exhaust vent to dryer exhaust outlet.

102 mm (4")

clamp

5. Move dryer into final position.

102 mm (4")

clamp

Reverse Door Swing (Optional)

You can change your door swing from a right-side opening to a

left-side opening, if desired.

1. Place towel (A) on top of dryer to protect surface.

2. Open dryer door. Remove bottom screws from cabinet side

of hinges (B). Loosen (do not remove) top screws from

cabinet side of hinges.

3. Lift door until top screws in cabinet are in large part of hinge

slot. Pull door forward off screws. Set door (handle side up)

on top of dryer. Remove top screws from cabinet.

4. Remove screws attaching hinges to door.

5. Remove screws at top, bottom, and side of door (5 screws).

Holding door over towel on dryer, grasp sides of outer door

and gently lift to separate it from inner door. Do not pry apart

with putty knife. Do not pull on door seal or plastic door

catch.

6. Be certain to keep cardboard spacer centered between

doors. Reattach outer door panel to inner door panel so

handle is on the side where hinges were just removed.

7. Attach door hinges to dryer door so that the larger hole is at

the bottom of the hinge.

8. Remove the 4 screws that attach 2 plugs on the left side.

Attach plugs to right side using the same 4 screws.