Whirlpool 8314832A Use And Care Manual - Page 12

Browse online or download pdf Use And Care Manual for Dryer Whirlpool 8314832A. Whirlpool 8314832A 28 pages. Electric and gas dryers

Print Page

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid

the cost of a service call...

Clothes are not drying satisfactorily

Check the following:

Is the lint screen clogged with lint?

Is the exhaust vent or outside exhaust hood clogged with lint,

restricting air movement? Run the dryer for 5-10 minutes.

Hold your hand under the outside exhaust hood to check air

movement. If you do not feel air movement, clean exhaust

system of lint or replace exhaust vent with heavy metal or

flexible metal vent. See your Installation Instructions.

Is the exhaust vent crushed or k ink ed? Replace with heavy

metal or flexible metal vent. See your Installation Instructions.

Has a fuse blown, or a circuit break er tripped? Electric dryers

use 2 household fuses or break ers. The drum may be turning

but you may not have heat.

Has an Air Dry cycle been selected? Select the right cycle for

the types of garments being dried (see "Drying, Cycle and

Temperature Tips").

For gas dryers, is the valve open on the supply line?

Are fabric softener sheets block ing the grill? Use only one

fabric softener sheet and only use it once.

Is the dryer located in a room with temperature below

45ºF (7ºC)?

Proper operation of dryer cycles requires temperatures above

45ºF (7ºC).

Was a cold rinse water used? Was the load very wet?

Expect longer drying times with items rinsed in cold water

and with items that hold moisture (cottons).

Is the load too large and heavy to dry quickly?

Separate the load to tumble freely.

Dryer will not run

Check the following:

Is the power cord plugged in?

Has a fuse blown, or has circuit break er tripped?

Was a regular fuse used? Use a time-delay fuse.

Is the dryer door firmly closed?

Was the START button firmly pressed?

Is a cycle selected?

Unusual sounds

Has the dryer had a period of non-use?

If the dryer hasn't been used for a while, there may be a

thumping sound during the first few minutes of operation.

Is it a gas dryer?

The gas valve click ing is a normal operating sound.

Lint on load

Is the lint screen clogged?

Clean lint screen. Check for air movement.

Is load properly sorted?

Sort lint givers (towels, chenille) from lint tak ers (corduroy,

synthetics). Also sort by color.

Is the load too big or too heavy?

Dry smaller loads so lint can be carried to the lint screen.

Was the load overdried?

Use correct dryer settings for load type (see "Drying, Cycle

and Temperature Tips"). Overdrying can cause lint-attracting

static electricity.

Was paper or tissue left in pockets?

Clean out pock ets before drying.

Is pilling being mistaken for lint?

Pilling (surface fuzz) is caused by normal wear and

laundering.

Stains on load or color change

Was dryer fabric softener properly used?

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially-dried load can

stain your garments.

Were items soiled when placed in the dryer?

Items should be clean before being dried.

Were items properly sorted?

Sort light colors from dark colors. Sort colorfast items from

noncolorfast items.

Items shrinking

Was the dryer overloaded?

Dry smaller loads that can tumble freely.

Did the load overdry?

Check the manufacturer's care label. Match dryer setting to

load type (see "Drying, Cycle and Temperature Tips").

Loads are wrinkled

Was load removed from dryer at the end of the cycle?

Remove load as soon as tumbling stops.

Was dryer overloaded?

Dry smaller loads that can tumble freely.

Did load overdry?

Check the manufacturer's care label. Match dryer setting to

load type (see "Drying, Cycle and Temperature Tips").

Odors

If the dryer is electric, is it being used for the first time?

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

If the dryer is gas, there may be a gas leak:

Turn off the gas supply line, leave your house and then call

your local gas company.

Have you recently been painting, staining or varnishing in

the area where your dryer is located?

If so, ventilate the area. When the odors or fumes are gone

from the area, re-wash the clothing and then dry it.