Whirlpool CGM2761TQ1 Installation Instructions Manual - Page 16

Browse online or download pdf Installation Instructions Manual for Dryer Whirlpool CGM2761TQ1. Whirlpool CGM2761TQ1 36 pages. Commercial gas or electric dryer

Print Page

CHANGING TO A 30- OR

SO-MINUTE TIMINGCAM

Emectricat Shock Hazard

Disconnect

power before making cam changes.

Failure to follow

these }nstructions

can resumt }n death

or electrical

shock.

You can install the 30-minute or 60-minute timing cam (shipped

with dryer) as follows:

1, Unplug dryer or disconnect power.

2, Unlock meter case.

3, Turn the timing cam by hand until the V-shaped notch lines up

below the ratchet tooth.

B. Timing cam

C. Drive lug

D. V-shaped notch

4, Insert a narrow, fiat-blade screwdriver under the timing cam

near the clock shaft. Gently Iift cam straight up and off shaft

making sure that the V-shaped notch clears the ratchet tooth.

5, Place new cam (hub side down) over clock shaft. Line up fiat

side of shaft with fiat side of cam hole. Check that drive Iug is

in place.

6, Turn cam until V-shaped notch lines up with ratchet tooth.

7, Press cam down in place on motor shaft. Make sure that

',i-shaped notch ciears the ratchet tooth.

8, Close and lock the meter case.