Whirlpool WGD70HEBW Installation Instructions Manual - Page 15
Browse online or download pdf Installation Instructions Manual for Dryer Whirlpool WGD70HEBW. Whirlpool WGD70HEBW 44 pages. Whirlpool duet 7.4 cu. ft. front load electric dryer with eco monitor
Also for Whirlpool WGD70HEBW: Instruction Manual (8 pages), Installation Manual (44 pages), Use And Care Manual (40 pages)
Print Page
COMPLETE INSTALLATION
CHECKLIST
❑
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
❑
Check that you have all of your tools.
❑
Dispose of/recycle all packaging materials.
❑
Be sure the water faucets are on.
❑
Check for leaks around "Y" connector, faucet, and hoses.
❑
Check dryer's final location. Be sure vent is not crushed
or kinked.
❑
Check that dryer is level. See "Level Dryer".
❑
Remove film on console and any tape remaining on dryer.
❑
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
❑
Read "Dryer Use" in your "Use and Care Guide".
❑
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
Electric Models
❑
Plug into a grounded outlet.
Gas Models
❑
Plug into a grounded outlet.
❑
Check that gas supply is on.
❑
Check for leaks.
❑
Check to be sure that the flexible gas line is not crushed
or kinked.
All Models:
❑
Select a Timed Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
connected.
not tripped.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated. This
odor is common when heating element is first used. The odor will
go away.
DOOR REVERSAL (OPTIONAL)
The following instructions are for models with a round and
square-shaped doors.
Tools needed:
Min. 8" long TORX
®
T25
††
screwdriver
Reverse door swing round-shaped door - single handle
1.
Remove door from dryer
IMPORTANT: If the protective film has not yet been
removed from the dryer, peel the film from the dryer
door before proceeding.
Using a TORX T25 screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws in the holes.
††
® TORX is a registered trademark of Saturn Fasteners, Inc.
#2 Phillips screwdriver
15