Whirlpool WGD7300DW Use & Care Manual - Page 11
Browse online or download pdf Use & Care Manual for Dryer Whirlpool WGD7300DW. Whirlpool WGD7300DW 40 pages. Gas and electric dryer 29" wide models
Also for Whirlpool WGD7300DW: Installation Instructions Manual (44 pages)
Print Page
TIMED DRY Cycle:
When you select Timed Dry, the default time appears in the
display. Touch "+" and "–" to increase or decrease the time
in 1 minute increments. Touch and hold to change the time
in 5 minute increments.
The default temperature may be changed by touching
Temperature until the desired dry temperature is lit.
Steam Refresh Cycles (on some models):
Select Steam Refresh to reduce odors and light wrinkles in
dry loads consisting of wrinkle-free cotton, cotton-polyester
blends, common knits, and synthetics. If you will be unable
to remove a load immediately, touch Wrinkle Shield
up to 150 minutes of periodic tumbling. You may select the
+ Steam setting to add a short steam cycle after 60 minutes
to help smooth out wrinkles.
5.
Adjust cycle modifiers, if desired
You may adjust different settings,
depending on what you are drying and
how you are going to dry the item. See
the "Cycle Guide" for detailed information.
NOTE: Not all options and modifiers are
available with all cycles. Not all cycles
are on all models.
6.
Select any additional options
Add additional options such as Static Reduce, End Beep,
and/or Wrinkle Shield
(on some models) by touching that
™
option. If you will be unable to remove the load promptly,
select Wrinkle Shield
before touching START/PAUSE. You
™
may select the "+ Steam" setting (on some models) to add
a short steam cycle after 60 minutes to help smooth out
wrinkles.
NOTE: Not all options and settings are available with all
cycles.
7.
Touch and hold START/PAUSE
to begin cycle
to add
™
Touch and hold START/PAUSE to begin the cycle.
8.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has completed
to reduce wrinkling.
Changing the Automatic Cycle settings
to increase or decrease drying time
If all your loads on all Automatic Cycles are consistently less
dry or more dry than you would like, you may change the
default settings to increase or decrease the default dryness
level.
Your automatic drying settings can be adjusted to adapt to
different installations, environmental conditions, or personal
preference. This change is retained and will affect all of your
Automatic Cycles, not just the current cycle/load. There are
5 drying settings, which are displayed using the time display:
0 Much wetter clothes, 30% less drying time.
1 Slightly wetter clothes, 15% less drying time.
2 Factory preset dryness level.
3 Slightly drier clothes, 15% more drying time.
4 Much drier clothes, 30% more drying time.
To change the drying settings:
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby mode
(power is off) to adjust the default settings.
1. Before starting a cycle, touch and hold DRYNESS
for 6 seconds.
2. Touch DRYNESS to select the dryness level shown in
the time display: 0, 1, 2, 3, or 4.
3. Touch START/PAUSE to save the new dryness level
setting.
11