Whirlpool WGD7300XW Use And Care Manual - Page 14

Browse online or download pdf Use And Care Manual for Dryer Whirlpool WGD7300XW. Whirlpool WGD7300XW 32 pages. Installation instructions
Also for Whirlpool WGD7300XW: Installation Instructions Manual (36 pages)

Print Page

Stains on load or drum

■

Was dryer fabric softener properly used?

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can stain

your garments.

Drum stains are caused by dyes in clothing (usually blue

jeans). This will not transfer to other clothing.

Loads are wrinkled

■

Was the load removed from dryer at the end of the cycle?

For Steam Dryers select Enhanced Touch Up Cycle to tumble

the load with water and heat to help smooth out wrinkles from

a load left in the dryer.

■

Was the dryer overloaded?

Dry smaller loads that can tumble freely. Smaller loads of one

to four garments yield best results with Quick Refresh Cycle.

Results may also vary depending on fabric type. This cycle is

best for reducing wrinkles and odors from loads consisting of

wrinkle-free cotton, cotton polyester blends, common knits,

and synthetics.

■

Loads are still wrinkled following Steam cycle on Steam

models?

Make sure water is connected to the dryer. Check that water

inlet hose is connected to both the faucet and dryer's water

inlet valve. Check that the water supply is turned on. This

cycle is best for smoothing out wrinkles and reducing odors

from loads consisting of wrinkle-free cotton, cotton polyester

blends, common knits, and synthetic garments.

NOTE: Refer to garment care label instructions. Dry clean only

garments are not recommended.

Odors

■

Have you recently been painting, staining, or varnishing in

the area where your dryer is located?

If so, ventilate the area. When the odors or fumes are gone

from the area, rewash and dry the clothing.

■

Is the dryer being used for the first time?

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

■

Is water connected to the dryer for Steam models?

Check that water inlet hose is connected to both the faucet

and dryer's water inlet valve. Check that the water supply is

turned on.

■

To remove odors left in garments after wearing, select Steam

Cycle. These cycles are best for reducing odors from loads

consisting of wrinkle-free cotton, cotton polyester blends,

common knits, and synthetics.