Whirlpool WGD96HEAU Installation Instructions Manual - Page 21
Browse online or download pdf Installation Instructions Manual for Dryer Whirlpool WGD96HEAU. Whirlpool WGD96HEAU 44 pages. 7.4 cu. ft. duet steam gas dryer with advanced moisture sensing
Also for Whirlpool WGD96HEAU: Instruction Manual (8 pages), Use & Care Manual (40 pages)
Print Page
2.
Move the door strike
Using a TORX
T25 screwdriver, remove the 2 screws
®
securing the door strike to the door frame of the dryer.
Remove the 4 screws above and below the door strike and
set aside for later use. Rotate the strike 180° and attach to
the opposite side of dryer door frame, as shown.
3.
Remove inner door from
outer door
Release tab
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 13 screws securing the
inner door to the outer door. Lift off the inner door and set
aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.
4.
Latch
Using a TORX T25 screwdriver, remove the 3 TORX screws
securing the latch plate and the 5 screws holding the hinge
assembly in place.
5.
Latch
Release tab
Using a TORX T25 screwdriver, reinstall the latch plate and
hinge assembly on the opposite sides from which they were
removed.
Remove hinge and latch
from inner door
Reinstall hinge and latch on
opposite sides
Hinge
Latch
21