Whirlpool WHD5090GW0 Use & Care Manual - Page 14
Browse online or download pdf Use & Care Manual for Dryer Whirlpool WHD5090GW0. Whirlpool WHD5090GW0 36 pages. Heat pump dryer
Print Page
INSTALLATION INSTRUCTIONS
Installation Requirements
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Min. 8" long TORX
T20
®
®†
screwdriver
Wire stripper (direct wire
installations)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
Level
14
#2 Phillips screwdriver
1/4" and 5/16" nut driver
(recommended)
Channel locks
Pliers
Tape measure
If using a power supply cord:
Use a UL-listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL-listed 30-amp power supply cord, rated 120-/240-volt
n
minimum. The cord should be type SRD or SRDT and
be at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
Additional Accessories:
Refer to "Operating Instructions" for information about
accessories available for your dryer.
†® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
(Not supplied with dryer)