Whirlpool YLEW0050PQ0 Use & Care Manual - Page 4
Browse online or download pdf Use & Care Manual for Dryer Whirlpool YLEW0050PQ0. Whirlpool YLEW0050PQ0 32 pages. 240.volt electric dryer
Print PageINSTALLATION REQUIREMENTS
Tools needed
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
•
Flat-blade screwdriver
•
Tin snips (new vent
•
Adjustable wrench
installations)
•
T20 TORX _t screwdriver
•
Wood block
•
Caulking gun and
•
Level
compound
(for installing
•
Vent clamps
new exhaust vent)
Parts supplied
Remove parts package from the dryer drum. Check that all parts
listed are included.
Coupling
Parts needed
Check local codes, existing electrical supply and venting, and
see "Venting Requirements"
and "Electrical Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system
hardware. For ordering information, please refer to the
"Assistance
or Service" section of this manual. You may also
contact the dealer from whom you purchased your dryer.
Pedestal
You may order a pedestal separately for this dryer. This pedestal
will add about 12" (30.48 cm) to the height of your unit for a total
height of approximately
45" (114.3 cm).
Stack Kit
Are you planning to stack your washer and dryer? To do so, you
will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance or Service" section of this manual. Ask
for Part Number 8182452.
Explosion
Hazard
Keep flammable
materials and vapors, such as
gasoline,
away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion,
or fire.
You will need
•
A location that allows for proper exhaust installation. See
"Venting Requirements."
A separate 30-amp circuit.
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
A sturdy floor to support the dryer weight (dryer and load) of
115 Ibs (52 kg). The combined weight of a companion
appliance should also be considered.
A level floor with a maximum slope of 1" (2.5 cm) under entire
dryer.
Do not operate your dryer at temperatures
below 45°F (7°C). At
lower temperatures,
the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes or
sleeping quarters. Contact your local building inspector.
Optional pedestal
To order, call the dealer from whom you purchased your dryer or
refer to the "Assistance
or Service" section of this manual. Ask
for Model Number LAB0050PQ.
t®TORX
is a registered
trademark of Textron Innovations
Inc.