Whirlpool 36" (91.4 cm) WALL-MOUNT CANOPY RANGE HOOD Installation Instructions And Use And Care Manual - Page 8
Browse online or download pdf Installation Instructions And Use And Care Manual for Ventilation Hood Whirlpool 36" (91.4 cm) WALL-MOUNT CANOPY RANGE HOOD. Whirlpool 36" (91.4 cm) WALL-MOUNT CANOPY RANGE HOOD 28 pages. 36" (91.4 cm) wall-mount canopy range hood
Print PageNon-vented (recirculating) installation
1. Assemble the 3 parts of the deflector with 2 screws provided.
The assembled deflector should be sized to fit the width of
the vent cover bracket installed earlier.
A. Vent cover bracket width
B. Deflector
2. Connect the deflector to the vent cover bracket using 4
screws provided.
A. Vent cover bracket
3. Measure length of 8" (20.3 cm) vent needed to connect the
transition to the deflector.
NOTE: Vent should fit up inside deflector 1" (2.5 cm)
minimum.
4. Install vent between the transition and the deflector.
5. Seal all connections with duct tape.
8
A
B
A
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove terminal box cover.
3. Remove the knockout.
A
B
4. Install the UL- or CSA-listed conduit connector.
A
B
A. Conduit
B. Terminal box cover
C. Conduit connector
5. Run 3 wires, black, white and green (14 AWG) in ¹⁄₂" conduit
from service panel to terminal box.
6. Use twist-on connectors and connect black wires together.
7. Use twist-on connectors and connect white wires together.
A. Knockout
B. Terminal box cover
C