Whirlpool 36'' Freestanding Gas Range Installation Instructions And Use & Care Manual - Page 6

Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool 36'' Freestanding Gas Range. Whirlpool 36'' Freestanding Gas Range 28 pages. 30" and 36" gas sealed burner cooktop
Also for Whirlpool 36'' Freestanding Gas Range: Installation Instructions Manual (13 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (7 pages), Installation Instructions Manual (7 pages), Installation Instructions Manual (28 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (7 pages), Installation Instructions (5 pages)

Print Page

NOTES:

Depending on your model, determine which venting method

to use: roof, wall or non-vented (recirculating).

It is recommended that the vent system be installed before

the range hood is installed. Go to "Venting System" in the

"Installation Requirements" section if you need assistance.

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for the vent system.

1. Disconnect power

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

2. Mark Hole Locations

Align the exterior edge of the mounting brackets with the exterior

edges of the upper cabinet.

IMPORTANT: The brackets should touch the upper cabinet.

With a pencil, mark the upper holes on the brackets.

INSTALLATION INSTRUCTIONS

3. Install Brackets

Using a #2 Phillips screwdriver, install the drywall anchors.

Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,

install the mounting brackets using the upper holes.

NOTE: For installations to a surface other than drywall, it is

recommended that a qualified contractor determine the

anchoring method.

Set the range hood on its back on a covered surface.

Using a #2 Phillips screwdriver, remove the rectangular

damper attached with 3.5 x 9.5 mm screws.

Using a #2 Phillips screwdriver, remove the electrical box

cover.

Using a flat-blade screwdriver, remove the appropriate power

supply knockout.