Whirlpool GZ5730XR Series Installation Instructions And Use & Care Manual - Page 9
Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool GZ5730XR Series. Whirlpool GZ5730XR Series 24 pages. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Also for Whirlpool GZ5730XR Series: Dimensions (1 pages), Installation Instructions And Use And Care Manual (24 pages), Installation Instructions And Use & Care Manual (24 pages), Installation Instructions And Use And Care Manual (24 pages)
Print Page
6, Connect thepower s upply g round w ire tothegreen g round
connector and tighten s ecurely.
3, Position therange h ood sothatthelarge e ndofthekeyhole
slots areover t hescrews. Then push thehood toward t hewall
sothatthescrews areintheneck oftheslots.
.... A
A. Green ground connector
7, Securely tighten the strain relief.
8, Replace the wiring cover.
UL-Listed
Power
Supply
Cord Kit {U.S. Only}
1, Connect a ULqisted Power Cord Kit (part no=99524057) (U.S=
only) following the kit instructions for connecting the wires.
2, Replace the wiring cover.
A, Keyhole slots (4)
B. Mounting screw
4, Tighten mounting screws to cabinet, making sure mounting
screws are in narrow neck of slots.
On vented installations:
5, Make sure that damper blade opens and closes freely.
6, Connect ventwork to hood. Sea! joints with duct tape to make
them secure and air tight.
Remove the 4 hood mounting screws from the parts bag and
install in previously drilled 1/8"(3.0 mm) pilot holes. Leave
screw heads about 1/4"(6.4 mm) away from shim strips.
1, Install (2) PAR20, 50W maximum halogen bulbs or (2) R16,
40W maximum incandescent
bulbs. Bulbs purchased
separately.
2, Replace filters.
NOTE: Filter slot must be toward front of hood.
For non-vented installations: Attach the charcoal filters (not
supplied) to the aluminum filters with the special blue and
yellow strips facing toward the cooking surface. Make sure
fan blade turns freely.
3, Reconnect power.
4, Check for proper operation.
2, Lift range hood into final position, feeding electrical wire
through wiring opening. To avoid damage, do not push on fan
blade.