Whirlpool GZ5736XRQ0 Installation Instructions And Use & Care Manual - Page 6
Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool GZ5736XRQ0. Whirlpool GZ5736XRQ0 24 pages. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Also for Whirlpool GZ5736XRQ0: Parts Manual (1 pages)
Print Page
iNSTALLATiON iNSTRUCTiONS
1. If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to upper
cabinet or rear wall. Slide cardboard or hardboard under
range before moving range across floor to prevent damaging
floor covering. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
or dirt.
2. Determine which venting method (roof or wall venting or
non-venting) you need to use. This range hood is shipped for
non-vented installation.
7" {17,8 cm) round
vertica_
vent
system
centerline
I
I
,,
8" (20.3 ore)
"_.
_
7 F*
dia. hole.\
i"
i
(19_1 cm)
!
i
,
wall
5"
1W' (3,2 cm)
2"
(122 cm)
dis, hole
(5_1cm)
3,
4,
wood shim strips
(recessedcabinet
bottoms only)
wall
W' (3.0 ram)
1F,"
pilot holes
(3.8 cm)
Hood size
A
30" (76.2 cm)
13_% '' (35.4 cm)
36" (91.4 cm)
16_5A6 '' (43.0 cm)
Drill four 1/_,, ( 3.0 mm) pilot holes for hood mounting screws. If
cabinet has recessed bottom, add wood shim strips on each
side.
From the following diagrams, select the diagram for your
installation.
Vented installations: Cut the vent system and electrical wiring
access holes as required.
Non-vented installations: Drill only the 11/4"(3.2 cm) dis. wiring
access hole required.
[]
If wiring through the top, use location shown in vertical
vent systems.
[]
If wiring through the back, use location shown in
horizontal vent system.
31/4" x 10" {8,3 x 25,4 cm) rectangular
vertica_
vent
system
5w'
31/4"x 10" (8,3 x 25,4 cm) horizonta_ vent system
centerline
""..q
1 ¼" (3.2 cm)
/_
.
!
i
(9_5 cm)
15;_;_
i_-----_@
7 ,/,,, (19.1 cm)
( .
)
1. Set the hood on a protective covering such as cardboard or a
large towe!. Remove the 7" (17.8 cm) round vent plate from
top of hood. Set vent plate and mounting screws aside.
2"
(12.7 cm)
(3.2 cm)
dis. hole
(5.1 cm)
A. 7" (17,8 cm) round vent plate